SECTION 1: IDENTIFICATION OF THE SUBSTANCE/MIXTURE AND OF THE COMPANY

Transcription

1 Classified as hazardous according to criteria of Worksafe Australia SECTION 1: IDENTIFICATION OF THE SUBSTANCE/MIXTURE AND OF THE COMPANY 1.1 Product Identifier Trade Name: Other Names: None Listed Product Code: Relevant identified uses of the product Application: Adhesive for AAC Panel 1.3 Details of the supplier: Company Details Rockcote Enterprises Pty Ltd (ABN ) Address 18 Machinery Road, Yandina Qld 4561 Telephone/Fax Tel (07) Fax (07) Emergency Telephone Other Information Note: For the most up-to-date information for this data sheet, please refer to the ROCKCOTE website. The information contained in this safety data sheet is accurate on the date of issue and in accordance with the information available at that time. Persons dealing with products referred to in this safety data sheet do so at their own risk. ROCKCOTE accepts no liability whatsoever for damage or injury, however caused, arising from use of this information or of suggestions contained herein. SECTION 2: HAZARDS IDENTIFICATON 2.1 Classification of product Skin Irritation. 2. H315; Eye Irritation. 2A H319; STOT SE. 3. H335; STOT RE. 2 H Label Element Pictograms: Signal Word: Hazard Statements: Exclamation Mark; Health Hazard WARNING H373 May cause damage to organs through prolonged or repeated exposure H319 Causes serious eye irritation H335 May cause respiratory irritation H315 Causes skin irritation Page 1 of 7

2 Precautionary Statements: P304+P340 P332+P313 P501 P305+P351+P338 P312 P260 P280 IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. If skin irritation occurs: Get medical advice/attention. Dispose of contents/container in accordance with local regulations. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do so. Continue rinsing. Call a POISON CENTER or doctor/physician if you feel unwell. Do not breathe dust/fume/gas/mist/vapours/spray. Wear protective gloves, eye and face protection 2.3 Other Hazards Other Hazards: SECTION3: COMPOSITION/INFORMATION ON INGREDIENTS 3.1 Mixtures The product contains: cement The following substances shall be indicated according to legislation: % CAS-No. Chemical Name Hazard Classification 40-70% - Non Hazardous Not Relevant 30-60% Portland Cement Non Hazardous STOT SE 3;H335 Skin Irritation. 2;H315 Eye Irritation. 2;H319 STOT RE 2;H373 SECTION 4: FIRST AID MEASURES 4.1 Description of first aid measures Inhalation: Move subject to fresh air. Monitor and consult physician if concerned. Skin Contact: Wash affected areas thoroughly with soap & water. Consult a physician if irritation persists. Eye Contact: Flush eyes with large amount of water for at least 15 minutes, holding the eyelids apart. Consult a physician if irritation persists. Ingestion: Flush mouth with copious quantities of water. Consult a physician. 4.2 Symptoms caused by exposure Inhalation: Move subject to fresh air. Monitor and consult physician if concerned. Skin Contact: Dust may irritate moist skin. Prolonged exposure could result in allergic reaction such as a rash or burning sensation. Eye Contact: Contact with eye can cause permanent eye damage immediately seek first aid. Ingestion: Can cause irritation to the throat and stomach 4.3 Medical Attention and Special Treatment Page 2 of 7

3 SECTION 5: FIRE FIGHTING MEASURES 5.1 Suitable extinguishing media Extinguishing media: Non Flammable Material. Use suitable extinguishing media for the surrounding area. 5.2 Specific hazards. 5.3 Special protection equipment and precautions for firefighters Firefighters: When water is to be used as an extinguishing media, chemical-resistant clothing should be used along with respiratory protection. SECTION 6: ACCIDENTAL RELEASE MEASURES 6.1 Personal precautions, protective equipment and emergency procedures Personal precautions: Avoid inhalation or contact with skin 6.2 Environmental precautions Environmental precautions: Do not allow this product to be released in to storm water drains, creeks or open bodies of water. Dump in accordance with local regulations. 6.3 Methods and materials for containment and cleanup Cleaning up spillage: Vacuum where possible. Sweep with a brush or broom SECTION 7: HANDLING AND STORAGE 7.1 Precautions for safe handling Safe handling: Avoid contact with skin and eyes. Avoid dust. 7.2 Conditions for safe storage, including any incompatibilities Incompatibilities: None known Storage: SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION 8.1 Control Parameters Occupational exposure limits: CAS-No. Chemical Name Exposure Limits Type References Portland Cement, respirable dust 3 mg/m3 TWA USECHH Portland Cement, inhalable dust 10 mg/m3 TWA USECHH Exposure Controls Engineering measures: Personal protection: Respiratory equipment: Hand protection: Eye protection: Hygiene measures: Environmental Exposure Controls: Not available. Provide adequate ventilation. Observe occupational exposure limits and minimise the risk of inhalation of dust. Personal protection equipment should be chosen in discussion with the supplier of the personal protective equipment During dust-raising work: Use respiratory equipment with particle filter Wear protective gloves. Nitrile gloves are recommended, other types of gloves can be recommended by the glove supplier. Wear goggles/face shield. Remove contaminated clothing and wash the skin thoroughly with soap and water after work. Page 3 of 7

4 SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES 9.1 Physical and Chemical Properties Appearance: Grey powder Odour: Cement Odour Threshold: ph: Alkaline (approx. 12 when mixed with water) Flash point: Non-combustible Solubility in water: Miscible in water Stability: Stable 9.2 Other Information Volatile Component: Auto Ignition Temp: SECTION 10: STABILITY AND REACTIVITY 10.1 Reactivity Reactivity: None known 10.2 Chemical stability Chemical stability: 10.3 Conditions to avoid Conditions/materials to avoid: Product is stable under normal temperature conditions. This product will harden with the addition of water or moisture 10.4 Incompatible materials and possible hazardous reactions Incompatible materials: None known Hazardous reactions: 10.5 Hazardous decomposition products Hazardous decomposition products: SECTION 11: TOXICOLOGICAL INFORMATION 11.1 Information and symptoms related to exposure Acute Toxicity: No data available Skin Corrosion/Irritation: Repeated or prolonged exposure to skin can cause dermatitis. Serious Eye Damage/Irritation Exposure can cause conjunctivitis, blepharitis and general irritation to the eyes Respiratory or Skin Sensitisation: Dust can irritate airways. Prolonged exposure may cause coughing or wheezing Germ Cell Mutagenicity: Specific Target Organ Toxicity (STOT) Single Exposure: Repeated Exposure: Repeated exposure over a long period of time may cause coughing with phlegm, shortness of breath and wheezing. Aspiration Hazard: 11.2 Numerical measures of toxicity Numerical measures: Page 4 of 7

5 11.3 Immediate, delayed or chronic health effects from exposure Immediate: Irritation of the eyes, skin and respiratory tract. Delayed: Allergic skin reaction, coughing and wheezing Chronic: Increased chance of bronchitis, conjunctivitis, ulcers of the nose and dermatitis Exposure levels Exposure levels: 11.5 Interactive effects Inhalation: Skin contact: 11.6 Data limitations Data limitations: Increased chance of bronchitis, conjunctivitis, ulcers of the nose and dermatitis. Respiratory conditions such as asthma can increase risk of coughing and wheezing. Sensitivity of the skin can lead to greater risk of allergic skin reactions SECTION 12: ECOLOGICAL INFORMATION 12.1 Toxicity EcoToxicity: This product is not expected to be hazardous to the environment Degradability Degradability: When mixed with water, this product will form into a hard mass that is non-degradable 12.3 Bio-accumulative Potential Bio-accumulative potential: 12.4 Mobility in soil Mobility in soil: 12.5 Other adverse effects Other adverse effects: None known. SECTION 13: DISPOSAL CONSIDERATIONS 13.1 Waste disposal Waste disposal Dispose of waste in accordance with local regulations. Waste is considered hazardous. Material that has hardened (with the addition of water) is considered non-hazardous. The packaging is 100% recyclable; remove all traces of mixture from bag and dispose of in a recycling bin. Do not allow product to enter sewerage system as this will block the sewerage system. SECTION 14: TRANSPORT INFORMATION 14.1 UN number UN number: None allocated Page 5 of 7

6 14.2 Proper shipping name Proper shipping name: None allocated 14.3 Transport hazard class Transport hazard class: 14.4 Packing group Packing group: 14.5 Environmental hazards Environmental hazards: None allocated None allocated 14.6 Special precautions during transport Special precautions: 14.7 Hazchem code Hazchem code: SECTION 5: REGULATORY INFORMATION 15.1 Safety, health and environmental regulations specific for the product Regulations: 15.2 Poisons Schedule number Schedule number: Page 6 of 7

7 SECTION 16: OTHER INFORMATION This SDS has been compiled on the date at the top of the first page. The SDS is reviewed every 5 years, the latest version is available on the ROCKCOTE website, This SDS has been prepared as a completely renewed document to bring into line with the Code of Practice Preparation of Safety Data Sheets for Hazardous Chemicals, February This SDS will be updated from time to time, whenever new information becomes available or if there is a formulation change. GHS means Globally Harmonized System CAS means Chemical Abstract Service TWA means Time Weighted Average USECHH means Use and Standard of Exposure Chemical Hazardous to Health STOT means Specific Target Organ Toxicity STOT SE means Specific Target Organ Toxicity Single Exposure STOT RE means Specific Target Organ Toxicity Repeated Exposure Mg/m 3 milligrams per cubic metre This SDS has been prepared using information provided by the manufacturers of the ingredients contained in this product. This product is a mixture of ingredients. I have been trained in the safe use of this material. Date Signiature END OF SDS This SDS has been developed according to Worksafe Australia / NOHSC guidelines Page 7 of 7