Material Safety Data Sheet

Transcription

1 Material Safety Data Sheet Revision Number: Issue date: 08/27/ PRODUCT AND COMPANY IDENTIFICATION Product name: Product type: Company address: Henkel Corporation One Henkel Way Rocky Hill, Connecticut Loctite PL Polyurethane Roof & Flashing Sealant black Sealant Region: United States Contact information: Telephone: MEDICAL EMERGENCY Phone: Poison Control Center (toll free) or TRANSPORT EMERGENCY Phone: CHEMTREC (toll free) or HAZARDS IDENTIFICATION EMERGENCY OVERVIEW HMIS: Physical state: high viscosity HEALTH: *2 Color: Black FLAMMABILITY: 1 Odor: Slight, Solvent PHYSICAL HAZARD: 1 Personal Protection: See MSDS Section 8 WARNING: COMBUSTIBLE! HARMFUL IF INHALED. CAUSES EYE, SKIN AND RESPIRATORY TRACT IRRITATION. MAY CAUSE ALLERGIC SKIN AND RESPIRATORY REACTION. Relevant routes of exposure: Inhalation, Skin, Eyes, Ingestion Potential Health Effects Inhalation: Skin contact: Eye contact: Ingestion: Existing conditions aggravated by exposure: This product may cause sensitization by inhalation and skin contact. May cause respiratory tract irritation. As a result of previous repeated overexposures or a single large dose, certain individuals will develop isocyanate sensitization (chemical asthma) which will cause them to react to a later exposure to isocyanate at levels well below the TLV. Chronic overexposure to isocyanates has been reported to cause lung damage. Dryness of nasal passages, sore throat, cough, tightness of chest, shortness of breath. Persons suffering from allergic reactions to isocyanates should avoid contact with the product. Contact with skin can cause irritation and allergic reaction (sensitization) in some individuals. This product may discolor the skin. Contact with eyes will cause irritation. Ingestion of this product may cause nausea, vomiting and diarrhea. Development of preexisting skin or lung allergy symptoms may increase. Asthma. This material is considered hazardous by the OSHA Hazard Communication Standard (29 CFR ). See Section 11 for additional toxicological information. Page 1 of 6

2 3. COMPOSITION / INFORMATION ON INGREDIENTS Hazardous components CAS NUMBER % Limestone Methyl oleate Titanium dioxide Stoddard solvent Talc Propylidynetrimethyl trimethacrylate Calcium oxide Quartz (SiO2) Toluene-2,4-diisocyanate Carbon black FIRST AID MEASURES Inhalation: Skin contact: If inhaled, immediately remove the affected person to fresh air. Immediate medical treatment necessary. Wash affected area immediately with soap and water. If symptoms develop and persist, get medical attention. Remove contaminated clothes. Eye contact: In case of contact with the eyes, rinse immediately with plenty of water for 15 minutes, and seek immediate medical attention. Ingestion: Notes to physician: Do not induce vomiting, seek medical advice immediately. An individual having a dermal or pulmonary sensitization reaction to this material should be removed from further exposure to any diisocyanate.the physician's judgment should be used to control symptoms and clinical condition based on the individual reactions of the patient. 5. FIRE FIGHTING MEASURES Flash point: Autoignition temperature: 85 C (185 F) Certificate of supplier expected. Flammable/Explosive limits - lower: 0.9 % Flammable/Explosive limits - upper: 9.5 % Extinguishing media: Special firefighting procedures: Unusual fire or explosion hazards: Hazardous combustion products: Water fog. Foam Carbon dioxide. Wear self-contained breathing apparatus and full protective clothing, such as turn-out gear. In case of fire, keep containers cool with water spray. known Nitrous gases Irritating fumes. Isocyanate vapors. 6. ACCIDENTAL RELEASE MEASURES Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected personnel. Environmental precautions: Clean-up methods: Do not empty into drains / surface water / ground water. Ensure adequate ventilation. Scrape up spilled material and place in a closed container for disposal. Wear suitable protective clothing, gloves and eye/face protection. Page 2 of 6

3 7. HANDLING AND STORAGE Handling: Storage: Avoid contact with eyes, skin and clothing. Avoid extreme temperatures. Wash thoroughly after handling. Protect from moisture. Use only with adequate ventilation. For safe storage, store between 18.3 C (64.9 F) and 40 C (104 F) Avoid moisture. Keep in a cool, well ventilated area away from heat, sparks and open flame. Keep container tightly closed until ready for use. For information on product shelf life, please review labels on container or check the Technical Data Sheet. 8. EXPOSURE CONTROLS / PERSONAL PROTECTION Employers should complete an assessment of all workplaces to determine the need for, and selection of, proper exposure controls and protective equipment for each task performed. Hazardous components ACGIH TLV OSHA PEL AIHA WEEL OTHER Limestone 10 mg/m3 TWA 5 mg/m3 TWA Respirable fraction. 15 mg/m3 TWA Methyl oleate Titanium dioxide 10 mg/m3 TWA 15 mg/m3 TWA Stoddard solvent 100 ppm TWA 500 ppm (2,900 mg/m3) TWA 20 MPPCF TWA 2.4 MPPCF TWA Talc 2 mg/m3 TWA 0.1 mg/m3 TWA Respirable fraction. 0.3 mg/m3 TWA 50 ppm 1 mg/m3 TWA Propylidynetrimethyl trimethacrylate (SKIN) Calcium oxide 2 mg/m3 TWA 5 mg/m3 TWA Quartz (SiO2) Toluene-2,4-diisocyanate mg/m3 TWA Respirable fraction ppm TWA 0.02 ppm STEL (Sensitiser.) 2.4 MPPCF TWA 0.1 mg/m3 TWA 0.3 mg/m3 TWA 0.02 ppm (0.14 mg/m3) Ceiling1 Carbon black 3.5 mg/m3 TWA 3.5 mg/m3 TWA Engineering controls: Respiratory protection: Eye/face protection: Skin protection: Local exhaust ventilation is recommended when general ventilation is not sufficient to control airborne contamination below occupational exposure limits. Observe OSHA regulations for respiratory use (29 CFR ). Use a NIOSH approved air-purifying respirator if the potential to exceed established exposure limits exists. Respirator with combination filter for vapor/particulate. Safety glasses with side-shields. Full face protection should be used if the potential for splashing or spraying of product exists. Use impermeable gloves and protective clothing as necessary to prevent skin contact. Page 3 of 6

4 9. PHYSICAL AND CHEMICAL PROPERTIES Physical state: high viscosity Color: Black Odor: Slight, Solvent Odor threshold: ph: Vapor pressure: < 4 mm hg (20 C (68 F)) Boiling point/range: C (250 F F) Melting point/ range: Specific gravity: Vapor density: Heavier than air. Flash point: 85 C (185 F) Certificate of supplier Flammable/Explosive limits - lower: 0.9 % Flammable/Explosive limits - upper: 9.5 % Autoignition temperature: expected. Evaporation rate: < 0.1 Slower than butyl acetate., (Butyl acetate = 1) Solubility in water: Insoluble Partition coefficient (n-octanol/water): VOC content: < 4 %; < 44 g/l 10. STABILITY AND REACTIVITY Stability: Hazardous reactions: Hazardous decomposition products: Incompatible materials: Conditions to avoid: Stable under normal conditions of storage and use. Contact with moisture, other materials that react with isocyanates, or temperatures above 350 F (177 C), may cause polymerization. Irritating and/or toxic fumes and gases may be emitted upon the product's decomposition. nitrogen oxides Aromatic isocyanates. carbon oxides. carbon monoxide Hydrogen cyanide. Oxidizing agents. Alcohols. Water. Strong bases. Avoid moisture. Keep away from open flames, hot surfaces and sources of ignition. Prolonged exposure to heat. 11. TOXICOLOGICAL INFORMATION Acute dermal product toxicity: Acute inhalation product toxicity: May cause sensitization by skin contact. May cause sensitization by inhalation., Danger of serious damage to health by prolonged exposure by inhalation. Hazardous components NTP Carcinogen IARC Carcinogen OSHA Carcinogen (Specifically Regulated) Limestone No No No Methyl oleate No No No Titanium dioxide No Group 2B No Stoddard solvent No No No Talc No No No Propylidynetrimethyl trimethacrylate No No No Calcium oxide No No No Quartz (SiO2) Known carcinogen. Group 1 No Toluene-2,4-diisocyanate Anticipated carcinogen. Group 2B No Carbon black No Group 2B No Page 4 of 6

5 Hazardous components Limestone Methyl oleate Titanium dioxide Stoddard solvent Talc Propylidynetrimethyl trimethacrylate Calcium oxide Quartz (SiO2) Toluene-2,4-diisocyanate Carbon black Health Effects/Target Organs Nuisance dust No Target Organs Irritant, Respiratory, Some evidence of carcinogenicity Irritant, Central nervous system Irritant, Lung, Some evidence of carcinogenicity Irritant, Allergen Irritant, Corrosive, Eyes Immune system, Lung, Some evidence of carcinogenicity Allergen, Eyes, Irritant, Lung, Respiratory, Some evidence of carcinogenicity Respiratory, Some evidence of carcinogenicity 12. ECOLOGICAL INFORMATION Ecological information: 13. DISPOSAL CONSIDERATIONS Information provided is for unused product only. Recommended method of disposal: Hazardous waste number: Dispose of according to Federal, State and local governmental regulations. U223: Toluene Diisocyanate. 14. TRANSPORT INFORMATION The shipping classifications in this sections are for non-bulk packaging only (unless otherwise specified). Shipping classification may be different for bulk packaging. U.S. Department of Transportation Ground (49 CFR) Proper shipping name: Not regulated Hazard class or division: Identification number: Packing group: International Air Transportation (ICAO/IATA) Proper shipping name: Hazard class or division: Identification number: Packing group: Water Transportation (IMO/IMDG) Proper shipping name: Hazard class or division: Identification number: Packing group: Not regulated Not regulated 15. REGULATORY INFORMATION United States Regulatory Information TSCA 8 (b) Inventory Status: TSCA 12(b) Export Notification: CERCLA/SARA Section 302 EHS: CERCLA/SARA Section 311/312: CERCLA/SARA 313: California Proposition 65: All components are listed or are exempt from listing on the Toxic Substances Control Act Inventory. above reporting de minimus above reporting de minimus Immediate Health, Delayed Health, Fire above reporting de minimus This product contains a chemical known in the State of California to cause cancer. This product contains a chemical known to the State of California to cause birth defects or other reproductive harm. Page 5 of 6

6 Canada Regulatory Information CEPA DSL/NDSL Status: One or more components are not listed on, and are not exempt from listing on either the Domestic Substances List or the Non-Domestic Substances List. WHMIS hazard class: D.2.B, D.2.A, B OTHER INFORMATION This material safety data sheet contains changes from the previous version in sections: New Material Safety Data Sheet format. Prepared by: Mary Ellen Roddy, Sr. Regulatory Affairs Specialist DISCLAIMER: The data contained herein are furnished for information only and are believed to be reliable. However, Henkel Corporation does not assume responsibility for any results obtained by persons over whose methods Henkel Corporation has no control. It is the user's responsibility to determine the suitability of Henkel's products or any production methods mentioned herein for a particular purpose, and to adopt such precautions as may be advisable for the protection of property and persons against any hazards that may be involved in the handling and use of any of Henkel Corporation's products. In light of the foregoing, Henkel Corporation specifically disclaims all warranties, express or implied, including warranties of merchantability and fitness for a particular purpose, arising from sale or use of Henkel Corporation's products. Henkel Corporation further disclaims any liability for consequential or incidental damages of any kind, including lost profits. Page 6 of 6