For purchasing information visit: Manns Trade Extra Tough Pro Lacquer

Transcription

1 The following Safety Datasheet is provided by Manns Wood Finishes Direct cannot be held liable for the information contained within this document. For purchasing information visit: Manns Trade Extra Tough Pro Lacquer

2 Safety Data Sheet 1. IDENTIFICATION OF THE SUBSTANCE / PREPARATION AND THE COMPANY 1.1. Product Identifier Name 1.2. Relevant identified uses of the substance or mixture and uses advised against Product Use Name Catalyst 1.3. Details of the supplier of the safety data sheet Company Wood Finishes Direct LTD Address Unit B, 5 Acre Trade Estate, Park Farm Road, Folkestone, KENT, CT19 5DS Web Telephone +44 (0) Fax +44 (0) wood@finishes-direct.com address of the wood@finishes-direct.com competent person 1.4. Emergency telephone number Emergency telephone number +44 (0) Company Wood Finishes Direct LTD 7am - 7pm Mon - Fri, 8am - 5pm Sat, 10am - 4pm Sun. 2. HAZARDS IDENTIFICATION 2.1. Classification of the substance or mixture Classification - 67/548/EEC Main hazards Classification - (1999/45) Irritating to eyes. May cause sensitisation by skin contact. Harmful to aquatic organisms, may cause long-term adverse effects in the aquatic environment. Xi;R36. R43. R52/53. Classification - EC 1272/ Label elements Hazard picograms Page 1 of 7

3 2.1. Classification of the substance or mixture Signal Word Hazard Statement 2.2. Other Hazards 3. COMPOSITION/INFORMATION ON INGREDIENTS 3.1. Classification of the substance or mixture Chemical Name Index No. CAS No. EC No. REACH Cont. Classification Reg No (%w/w) (67/548) HEXAMETHYLENE DIISOCYANATE % R43 OLIGOMERS HEXAMETHYLENE-DI-ISOCYANATE <1 % T;R23 R42/43 Xi;R36/37/38 ISOPHORONE DI-ISOCYANATE <1 % T;R23 R42/43 Xi;R36/37/38 N;R51/53 N,N-DIMETHYLCYCLOHEXYLAMINE % Xn;R20/21/22. C;R34. N;R51/53. R10 OLIGOMERS OF ISOPHORONE % R43 DIISOCYANATE POLYOXYETHYLENE TRIDECYL % Xi;R41,R38. ETHER PHOSPHATE N;R51/53 The Full Text for all R-Phrases are Displayed in Section FIRST AID MEASURES 4.1. Description of first aid measures Inhalation Move the exposed person to fresh air at once. Rinse nose and mouth with water. Get medical attention if any discomfort continues. Eye contact Immediately flush with plenty of water for up to 15 minutes. Remove any contact lenses and open eyelids widely. If irritation persists: Seek medical attention and bring along these instructions. Skin contact Remove contaminated clothing immediately and wash skin with soap and water. Continue to rinse for at least 15 minutes. Ingestion Do not induce vomiting. Do not give anything to drink Most important symptoms and effects, both acute and delayed General Information The severity of the symptoms described will vary dependent on the concentration and the length of exposure Indication of any immediate medical attention and special treatment needed 5. FIREFIGHTING MEASURES 5.1. Extinguishing media Extinguish with foam, carbon dioxide or dry powder Special hazards arising from the substance or mixture Special fire fighting Keep up-wind to avoid fumes. Use water SPRAY only to cool containers! Do not put procedures water on leaked material. Page 2 of 7

4 5.3. Advice for firefighters Protective mesures in fire 6. ACCIDENTAL RELEASE MEASURES Self contained breathing apparatus and full protective clothing must be worn in case of fire Personal precautions, protective equipment and emergency procedures Wear protective clothing as described in Section 8 of this safety data sheet. Follow precautions for safe handling described in this safety data sheet. For personal protection, see section 8. Avoid inhalation of vapours and contact with skin and eyes Environmental precautions Collect and dispose of spillage as indicated in section 13. Contain spillages with sand, earth or any suitable adsorbent material Methods and material for containment and cleaning up Ensure that waste and contaminated materials are collected and removed from the work area as soon as possible in a suitably labelled container. Dam and absorb spillages with sand, earth or other non-combustible material. Wash contaminated area with water Reference to other sections 7. HANDLING AND STORAGE 7.1. Precautions for safe handling Spraying is permitted only in closed systems, spray cabinets or spray boxes with adequate ventilation. Avoid contact with water or humidity 7.2. Conditions for safe storage, including any incompatibilities Store in tightly closed original container in a dry, cool and well-ventilated place. Unsuitable containers: copper, zinc, aluminium, copper alloy, zinc alloy, aluminium alloy. Storage class Chemical storage Specific end use(s) 8. EXPOSURE CONTROLS/PERSONAL PROTECTION 8.1. Control parameters Name STD TWA - 8 hrs STEL - 15 min Notes HEXAMETHYLENE-DI-ISOCYANATE WEL 0.02 mg/m3(sen) 0.07 mg/m3(sen) ISOPHORONE DI-ISOCYANATE WEL 0.02 mg/m3(sen) 0.07 mg/m3(sen) WEL = Workplace Exposure Limit. Page 3 of 7

5 8.2. Exposure controls Appropriate Provide adequate ventilation, including appropriate local extraction, to ensure that engineering controls the defined occupational exposure limit is not exceeded. Provide eyewash station. Eye / face protection Skin protection - Handprotection Skin protection - Other Respiratory protection Hygiene measures 9. PHYSICAL AND CHEMICAL PROPERTIES Wear splash-proof eye goggles to prevent any possibility of eye contact. Protective gloves and goggles must be used if there is a risk of direct contact or splash. The most suitable glove must be chosen in consultation with the gloves supplier, who can inform about the breakthrough time of the glove material. Wear appropriate clothing to prevent any possibility of liquid contact and repeated or prolonged vapour contact. If ventilation is insufficient, suitable respiratory protection must be provided. Wash at the end of each work shift and before eating, smoking and using the toilet Information on basic physical and chemical properties Appearance Liquid Colour Colourless to pale yellow Odour Characteristic Odour threshold ph Melting point Initial boiling point Flash point 76 O C Evaporation rate Flammability (solid, gas) Vapour pressure Vapour density Relative density 25 C Partition coefficient Autoignition temperature Viscosity 200 mpas 25 Explosive properties Oxidising properties Solubility 9.2. Other information Conductivity Surface tension Gas group Benzene Content Lead content VOC (Volatile organic compounds) Page 4 of 7

6 10. STABILITY AND REACTIVITY Reactivity Chemical stability Stable under normal temperature conditions Possibility of hazardous reactions Conditions to avoid Avoid excessive heat for prolonged periods of time Incompatible materials Hazardous decomposition products 11. TOXICOLOGICAL INFORMATION Toxicological Information Inhalation Eye contact Skin Contact Ingestion 12. ECOLOGICAL INFORMATION Ecotoxicity Toxicity Bases, alkalis (inorganic). Bases, alkalis (organic). Alcohols, glycols. Amines. Fire creates: Carbon dioxide (CO2). Nitrogen. In high concentrations, vapours may irritate throat and respiratory system and cause coughing. Risk of serious damage to eyes. Irritating to eyes. May cause sensitisation by skin contact. Irritating to skin. May cause discomfort if swallowed. The product contains a substance which is harmful to aquatic organisms Persistence and degradability Degradability The product contains substances which are not expected to be biodegradable Bioaccumulative potential Mobility in soil Results of PBT and vpvb assessment Other adverse effects 13.DISPOSAL CONSIDERATIONS Waste treatment methods Disposal methods Dispose of waste and residues in accordance with local authority requirements. Do not allow runoff to sewer, waterway or ground. 14. TRANSPORT INFORMATION Road transport notes Road transport notes Road transport notes Road transport notes Not classified. Not classified. Not classified. Not classified. Page 5 of 7

7 Hazard pictograms UN number UN proper shipping name Transport hazard class(es) Packing group Environmental hazards Special precautions for user Transport in bulk according to Annex II of MARPOL and the IBC Code 15. REGULATORY INFORMATION Safety, health and environmental regulations/legislation specific for the substance or mixture Labelling Contains Risk phrases Safety phrases Chemical safety assessment Irritant HEXAMETHYLENE DIISOCYANATE OLIGOMERS OLIGOMERS OF ISOPHORONE DIISOCYANATE R36 Irritating to eyes. R43 May cause sensitisation by skin contact. R52/53 Harmful to aquatic organisms, may cause long-term adverse effects in the aquatic environment. S24/25 Avoid contact with skin and eyes. S26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. S30 Never add water to this product. S37 Wear suitable gloves. P4 Contains isocyanates. See information supplied by the manufacturer. S7/8 Keep container tightly closed and dry. Statuatory instruments The Chemicals (Hazard Information and Packaging for Supply) Regulations 2009 (S.I 2009 No. 716). Approved code of practice Guidance notes Safety Data Sheets for Substances and Preparations. Classification and Labelling of Substances and Preparations Dangerous for Supply. Workplace Exposure Limits EH40. CHIP for everyone HSG(108). Page 6 of 7

8 Powered by TCPDF ( 16. OTHER INFORMATION Risk phrases in full R10 Flammable. R20/21/22 Harmful by inhalation, in contact with skin and if swallowed. R23 Toxic by inhalation. R34 Causes burns. R36/37/38 Irritating to eyes, respiratory system and skin. R38 Irritating to skin. R41 Risk of serious damage to eyes. R42/43 May cause sensitisation by inhalation and skin contact. R43 May cause sensitisation by skin contact. R51/53 Toxic to aquatic organisms, may cause long-term adverse effects in the aquatic environment. General information This information is correct to the best of our knowledge and belief at the date of publication however no guarantee is made to its accuracy Page 7 of 7