MATERIAL SAFETY DATA SHEET HelioSeal PVS 210

Transcription

1 Page 1 of 6 MATERIAL SAFETY DATA SHEET HelioSeal PVS 210 Section One Product Information Distributor s Name: ADCO Products, Inc Business Phone No.: Emergency Phone No.: (CHEMTREC) Address: 4401 Page Ave, PO Box 457 Michigan Center, MI Product Name: HelioSeal PVS 210 Product Description: Sealant MSDS Preparer: ADCO Products Inc. Date Prepared: 9/8/2008 Revision: 0 Replaces Date: NA Section Two Molecular Composition Common Name or Chemical Name / CAS Number / Weight % trimethoxy(methyl)silane < 5.0 % Xi, F; R 11-36/38 EINECS: Phosphoric acid, 2-ethylhexyl ester < 2.0 % C; R 34 EINECS: methanol < 1.0 % T, F; R 11-23/24/25-39/23/24/25 EINECS: Additional information: Section Three Hazards Information POTENTIAL HEALTH EFFECTS: NA

2 HelioSeal PVS 210 Page 2 of 6 Section Four First Aid Measures After inhalation: Supply fresh air; consult doctor in case of complaints. After skin contact: Treat affected skin with cotton wool or cellulose, then wash and rinse thoroughly with water and a mild cleaning agent. After eye contact: Rinse opened eye for several minutes under running water, then consult a doctor. After swallowing: Call a doctor immediately. Section Five Fire Fighting Measures Suitable extinguishing agents: Water spray Alcohol resistant foam Fire-extinguishing powder Carbon dioxide For safety reasons unsuitable extinguishing agents: Water with full jet Special hazards caused by the material, its products of combustion or resulting gases: Formation of toxic gases is possible during heating or in case of fire. Protective equipment: Wear self-contained respiratory protective device. Section Six Accidental Release Measures Person-related safety precautions: Ensure adequate ventilation Measures for environmental protection: Do not allow to enter sewers/ surface or ground water Measures for cleaning/collecting: Pick up mechanically Section Seven Handling and Storage Handling: Information for safe handling: Use only in well ventilated areas. Information about protection against explosions and fires: No special measures are required when processing in the specified normal way. Keep in mind the product s thermal load when in storage!

3 HelioSeal PVS 210 Page 3 of 6 Storage: Requirements to be met by storerooms and receptacles: Prevent any seepage into the ground. Information about storage in one common storage facility: Store away from foodstuffs. Further information about storage conditions: Protect from frost. Keep receptacle tightly sealed. Protect from heat and direct sunlight. Store receptacle in a well ventilated area. Store in dry conditions. Section Eight Exposure Controls / Personal Protection Additional information about design of technical systems: No further data; see item 7. Components with limit values that require monitoring at the workplace: methanol PEL (USA): 260 mg/m³, 200 ppm REL (USA): Short-term value: 325 mg/m³, 250 ppm Long-term value: 260 mg/m³, 200 ppm TLV (USA): Short-term value: 328 mg/m³, 250 ppm Long-term value: 262 mg/m³, 200 ppm ; BEI IOELV (European Union): 260 mg/m³, 200 ppm Additional Occupational Exposure Limit Values for possible hazards during processing: methanol PEL (USA): 260 mg/m³, 200 ppm REL (USA): Short-term value: 325 mg/m³, 250 ppm Long-term value: 260 mg/m³, 200 ppm TLV (USA): Short-term value: 328 mg/m³, 250 ppm Long-term value: 262 mg/m³, 200 ppm ; BEI IOELV (European Union): 260 mg/m³, 200 ppm Personal protective equipment: General protective and hygienic measures: The usual precautionary measures for handling chemicals should be followed. Keep away from foodstuffs, beverages and feed. Wash hands before breaks and at the end of work. Breathing equipment: Not necessary if room is well-ventilated.

4 HelioSeal PVS 210 Page 4 of 6 Protection of hands: Protective gloves recommended if direct contact (with the product) may occur. Eye protection: Safety glasses recommended if direct contact (with the product) may occur. Section Nine Physical and Chemical Properties General Information Form: Paste Color: Black Odor: Characteristic Boiling Point/Boiling Range: Not determined Flash point: NA Ignition Temperature: Not determined Explosion Limits Lower: Not determined Upper: Not determined Vapor Pressure: (at 20 C) <100 hpa Density: 1.39 g/cm3 (at 20 C) Solubility in / Miscibility with water: Insoluble Solvent Content: VOC Content: 0.5% Section Ten Reactivity Thermal decomposition / conditions to be avoided: No decomposition if used according to specifications. Dangerous reactions Reacts with acids. Dangerous products of decomposition: In case of fire, the following substance(s) may occur: Phosphorus oxides (e.g. P2O5) Contact with water (or air humidity) liberates minor quantities of: Ethanoic acid Methanol Section Eleven Toxicological Information Acute toxicity: Primary irritant effect: On the skin: Prolonged or repeated contact with the skin may cause skin irritation

5 HelioSeal PVS 210 Page 5 of 6 Section Twelve Ecological Information General notes: Do not allow product to reach ground water, water course or sewage system. Section Thirteen Disposal Considerations Product: Recommendation: Disposal in accordance with official regulations Uncleaned packagings: Recommendation: Disposal must be made according to official regulations. Section Fourteen Transportation Data DOT Shipping Name: Not Regulated DOT Hazard Class: N. A. DOT Label: Non Hazardous UN/NA Number: N. A. IMDG: N.A. ICAO/IATA: N.A. Section Fifteen Regulatory Information Sara Section 355 (extremely hazardous substances): ethylenediamine Section 313 (Specific toxic chemical listings): methanol TSCA (Toxic Substances Control Act): All ingredients are listed. Proposition 65 Chemicals known to cause cancer: Chemicals known to cause reproductive toxicity for females: Chemicals known to cause reproductive toxicity for males: Chemicals known to cause developmental toxicity:

6 HelioSeal PVS 210 Page 6 of 6 Cancerogenity categories EPA (Environmental Protection Agency) ethylenediamine: D IARC (International Agency for Research on Cancer) NTP (National Toxicology Program) TLV (Threshold Limit Value established by ACGIH) ethylenediamine: A4 MAK (German Maximum Workplace Concentration) NIOSH-Ca (National Institute for Occupational Safety and Health) OSHA-Ca (Occupational Safety & Health Administration) Section Sixteen Other Information For industrial use only. Keep out of reach of children. The hazard information herein is offered solely for the consideration of the user, subject to his own investigation of compliance with applicable regulations, including the safe use of the product under every foreseeable condition. This information relates to the specific material designated and may not be valid for such material used in combination with any other materials or in any process. Such information is to the best of our knowledge and belief accurate and reliable as of the date compiled. However, no representation, warranty or guarantee is made as to its accuracy, reliability or completeness. It is the user s responsibility to satisfy himself as to the suitability and completeness of such information for his own particular use. We do not accept liability for any loss or damage that may occur from the use of this information nor do we offer warranty against patent infringement.