Page 1 SAFETY DATA SHEET Light Mineral Oil 1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION Product ID: Product Name: Synonyms: Chemical Family: Molecular Formula: Molecular Weight: Distributed by: SOL-LM250, SOL-LM4, SOL-LM10 Light Mineral Oil Liquid Paraffin; White Mineral Oil; Liquid Petrolatum Petroleum Hydrocarbon Oil CH3[CH2]nCH3 Variable Solvet 411-19 th Street South East Calgary, Alberta Canada T2E6J7 www.solvet.ca For information, call: (403) 456-2245 Emergency number: (613) 996-6666 (CANUTEC) 1-800 463-5060 OR (418) 656-8090 (Control Poison Center) 2. HAZARDS IDENTIFICATION NFPA Code: HMIS Code: Emergency Overview: Potential Health Effects: Eye Contact: Skin Contact: Inhalation: Ingestion: Health-0, Flammability-1, Reactivity-0 Health-0, Flammability-1, Reactivity-0 This product has been evaluated and does not require any hazard warning on the label under OSHA criteria Negligible effects; may act as a laxative. 3. COMPOSITION / INFORMATION ON INGREDIENTS Name Amount CAS # Light Mineral Oil, NF 100% 8042-47-5
Page 2 4. FIRST AID MEASURES Eye Contact: Skin Contact: Inhalation: Ingestion: Flush immediately with large amounts of water. If irritation occurs, call a physician. Wash exposed area of skin with soap and water. If skin irritation or an allergic reaction occurs, get medical attention. If adverse effects occur, remove to uncontaminated area. Get medical attention if symptoms persist. If symptomatic, call a physician or poison control center promptly. 5. FIRE FIGHTING MEASURES FLASH POINT: 280 o F (138 o C) minimum METHOD USED: Cleveland Open Cup FLAMMABLE LIMITS (LEL/UEL, %volume in air): AUTOIGNITION TEMPERATURE: FLAMMABILITY CLASSIFICATION: Slight hazard. Material must be preheated before ignition will occur (OSHA Class IIIB) EXTINGUISHING MEDIA: Agents approved for Class B hazards (e.g. dry chemical, carbon dioxide, foam, steam) or water fog. Do not uses of water as this will scatter the liquid and spread the fire. A water spray may be used to keep fire-exposed containers and surroundings cool. UNUSUAL FIRE AND EXPLOSION HAZARDS: May create dense smoke during combustion. Mild fire hazard when heated its flash point. FIREFIGHTING EQUIPMENT: Firefighters should wear full bunker gear, including a positive pressure selfcontained breathing apparatus. HAZARDOUS COMBUSTION PRODUCTS: Incomplete burning can produce carbon monoxide and/ or carbon dioxide and other toxic gases. 6. ACCIDENTAL RELEASE MEASURES Remove mechanically or contain on an absorbent material such as dry sand or earth. Remove all sources of ignition. Dike around spilled material. 7. HANDLING AND STORAGE Handling: Storage: No special requirements Store in a cool, well-ventilated area in sealed containers. Do not store in open or unlabelled containers. Store away from strong oxidizing agents or combustible material.
Page 3 8. EXPOSURE CONTROLS/ PERSONAL PROTECTION EYE: None required; however, use of eye protection is good industrial practice. SKIN: None required; however, use of protective gloves is good industrial practice. INHALATION: Avoid breathing mist. If ventilation is inadequate, use a NIOSH/MSHAcertified respirator that will protect against dust/mist. ENGINEERING CONTROLS: Control airborne concentrations below the exposure guidelines. EXPOSURE GUIDELINE LIMITS: OSHA PEL: 5 mg/m 3 (OIL MIST) (1989) (1971) ACGIH TLV-TWA: 5 mg/m 3 (oil mist) ACGIH TLV-STEL: 10 mg/m 3 (oil mist) 9. PHYSICAL AND CHEMICAL PROPERTIES Appearance Physical State: Oily Liquid Color: Colorless Odor: Odorless ph: Melting point: Boiling Point: Specific Gravity: 0.818 0.880 @ 25 o C / 25 o C (77 o F) Solubility: Negligible in water (below 0.1%); soluble in hydrocarbons. Pour point: 20 o F (-7 o C) maximum Readily Carbonizable Substances: Must pass USP Test 10. STABILITY AND REACTIVITY Stability: Conditions to Avoid: Materials to Avoid: Hazardous Decomposition: Hazardous Polymerization:. Stable Avoid excessive heat and open flames. Avoid chlorine, fluorine, and other strong oxidizers. None identified. Will not occur.
Page 4 11. TOXICOLOGICAL INFORMATION Acute Toxicity Data: EYE IRRITATION: SKIN IRRITATION: DERMAL LD50: ORAL LD50: INHALATION LC50: Other Toxicity Data: Specific toxicity tests have not been conducted on this product. Our hazard evaluation is based on information from similar products, the ingredients, technical literature, and/or professional experience. A similar product produced a primary eye irritation score (PEIS) of less than 10/110.0 (rabbits), a primary skin irritation score (PDIS) of less than 4.0/8.0 (rabbits), a dermal LD50 greater than 2000 mg/kg (rabbits), and an oral LD50 score greater than 5000 mg/kg (rats). Also, a similar product was not a skin sensitizer when tested. Oil mist: Repeated exposure to levels of oil mists in excess of the exposure limits may result in accumulation of oil droplets in pulmonary tissue and may lead to irritation of the nose and throat. No adverse health effect is expected to occur at or below the exposure limits. No component of this product present at levels greater than 0.1% is identified as a carcinogen by the U.S. National Toxicity Program, the U.S Occupational Safety and Health Act, or the International Agency on Research on Cancer (IARC). Ecological testing has not been conducted on this product. 12. ECOLOGICAL INFORMATION 13. DISPOSAL INFORMATION Disposal must be in accordance with applicable federal, state or local regulations. 14. TRANSPORT INFORMATION U.S Department of Transportation: Not regulated International Information: HS Code 2710.19.45 Canadian Transportation of Dangerous Goods: Not regulated
Page 5 15. REGULATORY INFORMATION CERCLA Sections 102A/103 Hazardous Substances (40 CFR Part 302.4): Not reportable SARA Title III Section 302 Extremely Hazardous Substances (40 CFR Part 355): Not regulated SARA Title III Sections 311/312 Hazardous Categorization (40 CFR Part 370): Not applicable SARA Title III Section 313 ($) CFR Part 372): Not regulated U.S. Inventory (TSCA): Listed on inventory. All components comply with TSCA. OSHA Hazard Communication Standard: Listed by ACGIH. Listed by OSHA. FOOD CONTACT STATUS: FDA 21CFR 172.878, Food Additives Permitted for Direct Addition to Food for Human Consumption- Multipurpose Additives. Meets requirements. FDA21 CFR 176.170, Components of paperboard in contact with aqueous and fatty foods. Meets requirements. FDA 21 CFR 178.3620, Certain adjuvants and production aids. Meets requirements. FDA 21 CFR 178.3570, Lubricants with incidental contact. Meets requirements. FDA 21 CFR 573.680, Food additives permitted in feed and drinking water of animals. Meets requirements. NSF H1 Lubricants with incidental food contact for use in official meat and poultry establishments: Meet requirements. NSF 3H Releasing agents on grills, loaf pans, boning blocks or other hard surfaces to help prevent food from adhering during processing: Meets requirements National Formulary (NF) Light Mineral Oil: Meets requirements Food Chemicals Codex- Mineral Oil: Meets requirements Kosher Status: Certified by OK Kosher Certification SDS Number: SOL009 SDS creation date: Oct 17, 2013 Revised date: Jan 13, 2016 Revision due: Jan 30, 2018 16. OTHER INFORMATION The information above is believed to be accurate and represents the best information currently available to us. However, we make no warranty of merchantability or any other warranty, express or implied, with respect to such information, and we assume no liability resulting from its use. Users should make their own investigations to determine the suitability of the information for their particular purposes. In no event shall Solvet be liable for any claims, losses, or damages of any third party or for lost profits or any special, indirect, incidental, consequential or exemplary damages, howsoever arising, even if Solvet has been advised of the possibility of such damages. This product has been classified in accordance with the hazard criteria of the CPR and the SDS contains all of the information required by the CPR