PCB Relays Safety Relay with double contacts monostable OA 621, OA 6 OA 621 OA 6 Acc. to DIN EN 020, DIN EN 618-1, DIN EN 60664-1 High switching safety because of gold plated double contacts Low rated power consumption Clearance and creepage distances. mm; that means double and reinforced insulation between all circuits High mechancial service life High temperature range High thermal continuous current Extremly flat: only 1. mm high Contact gap > 0. mm over entire service life, even when underfault and at 1.2 U N Voltage range 0.7... 1.2 U N Applications To be used in electrical circuits for safety applications Escalators and walkways Elevators for men and load Railway technology Approvals and Marking Canada / USA 1) 1) pending Technical Data Relay type OA 621 OA 6 OA 6.0 1.0 Coil 1.1 Nominal voltage DC V 6, 12, 24, 48, 60, 1 or others on request 1.2 Nominal consumption W 0.6 0.8 0.9 1.11 Voltage range U N 0.7... 1.2 1.12 Thermal resistance K/W (mounting distance between relays mm) 1.13 Holding capacity mw 200 2.0 Contacts 2.1 Contact arrangement 2 NO / 2 NC 3 NO / 1 NC 3 NO / 3 NC 4 NO / 2 NC NO / 1 NC 2 NO / 4 NC 2.2 Contact material AgNi µm Au 2.3 Rated insulation voltage AC V 20 Switching voltage min./max V AC/DC 0 mv / AC/DC 60 V (AC 20 V, DC 0 V) 1) 2.4 Limiting continuous current I th A 3 x x (s. operating voltage limit curve) Switching current min./max A AC/DC 1 ma / 0.3 A (AC A, DC 3 A) 1) 2. Switching power min./max. VA 1 mva / 7 VA (120 VA) 1) Switching power min./max. W 1 mw / 7 W (120 W) 1) 2.6 Switching capacity to IEC/EN 60947--1 AC 1 AC V/A NO: 20 / 3 NC: 20 / 1 to IEC/EN 60947--1 DC 13 DC V/A NO: 24 / 2 NC: 24 / 2 at 0.1 Hz DC V/A NO: 24 / 4 NC: 24 / 4 to UL 08 B300 / Q 300 2.7 Electrical life at 1 s On, 1 s Off (see contacts service life) at AC 230 V, A, cosj = 1 switching cycles > 2 x AgNi 0.1 at DC 24 V, 3 A ohmic switching cycles > 1. x AgNi 0.1 2.8 Switching frequency max switching cycles / s 2.9 Response time / Release time ms typically 12 / typically 8 2. Contact force cn 8 2.13 Contact resistance mω 0 (DC 2 V, 0 ma) 2.14 Contact gap mm > 0. 2) 3.0 Other 3.1 Mechanical life switching cycles > 20 x 6 3.2 Temperature range C - 40... 80 3.3 Degree of protection, housing Wash proof RT III 3. Vibration resistance NO:... 200 Hz; g; NC:... 140 Hz g; IEC/EN 60068-2-6 3.6 Climate resistance Humid heat IEC/EN 60068-2-30 3.7 Short circuit strength 1 ka / AC 20 V AgNi NO: AgL / NC: 6 AgL EN 60947--1 1) these higher values are possible but the gold plate will be destroyed 2) over entire service life, even when under fault and at 1.2 x UN All technical data in this list relate to the state at the moment of edition. We reserve the right for technical improvements and changes at any time. 1 OA 621, OA 6 D / 14.04.14 en / 430
Technical Data 3.8 Insulation acc. to IEC 60664-1, EN 0178 Rated insulation voltage AC V 20 Contamination level 2 Overvoltage category III Test voltage Contact-coil (1 min) AC kv eff. 4 Contact-contact (1min) AC kv eff. 4 Open contact acc. to DIN EN 618-1 AC kv eff. 1. Transient voltage Contact-coil ( - 0 µs) kv 6 Clearance and creepage distance mm, 3.9 Weight g approx. 3 approx. 38 approx. 38 4.0 Packing unit 4.1 on cardboard in slipcase piece 2 20 20 4.2 in case package piece 20 200 200.0 Solder method.1 Solder method /-temperature /-duration C / s Wafe soldering / 260 / Design Versions U N (DC V) Voltage range (DC V) R Coil Ω ± % OA 621 OA 6.48.2 R Spule.18.4.60 R Coil.0 3NO, 1NC 2NO, 2NC Ω ± % 3NO, 3NC 4NO, 2NC NO, 1NC Ω ± % 2NO, 4NC AgNi -contacts µm Au 6 4,... 8,4 60 3791 3801 4 3821 3831 3841 38 381 12 9,0... 16,8 240 3792 3802 180 38 3832 3842 382 24 18,08... 33,6 960 3793 3803 720 3823 3833 3843 600 383 48 36,0... 67,2 3840 3794 3804 2880 3824 3834 3844 242 384 60 4,0... 84,0 6000 379 380 400 382 383 384 3790 38 1 82,... 14,0 20000 3796 3806 112 3826 3836 3846 1273 386 Ordering Example OA 62_. / D _ Pin configuration 1 7 8 Design version Contact arrangement OA 621.48 3 NO, 1 NC.2 2 NO, 2 NC Contact arrangement OA 6.0 2 NO, 4 NC.18 3 NO, 3 NC.4 4 NO, 2 NC.60 NO, 1 NC 1 = 4-poles 2 = 6-poles 2 OA 621, OA 6 D / 14.04.14 en / 430
Characteristics UB UN 1,0 Umin 3xA 3x2A 0,3A Umax M3_b UB UN 1,0 xa x2a Umin 0,3A Umax M36_b 0 20 40 60 80 0 C 0 20 40 60 80 0 C Umgebungstemperatur Umgebungstemperatur Operating voltage limit curve OA 621 Operating voltage limit curve OA 6 20 M39_a Reduktionsfaktor F 1,0 0,9 0,7 0, 0,4 0,3 M68 b Schaltspannung U [ V ] 200 0 0 0,2 0,2 0,4 1 Leistungsfaktor (cos ) Schaltzahl = Schaltzahl (ohmisch) x Reduktionsf. F 0 Schaltstrom I [ A ] Reduction factor for inductive loads Limit curve for arc-free operation (load limit curve) 0 Electricallifeof the output contacts determined by DINEN 60947--1/Annex C.3 M4_b Nominal Operating Current x A DC13:24V DC1:24V AC1:230V AC1:230V 1 4 6 7 Operation Cycles Electrical life 3 OA 621, OA 6 D / 14.04.14 en / 430
OA 621 Dimensions, Pin Configuration, Connection Diagrams Pin Configurations D1 / D 46, 0, 0,4x 0,3 1, - 0 M3372_d 17, 2,, 6, 3,2 Pin Configuration D1 M3370_e M3371_e OA621.48/ D1 3NO / 1NC OA621.2/ D1 2NO / 2NC Pin Configuration D M3441_c OA621.48/ D 3NO / 1 NC Connection for basic grid divensions 2,0 mm as well as 2,4 mm according to DIN EN 60097, DIN EN 60326 4 OA 621, OA 6 D / 14.04.14 en / 430
OA 621 Dimensions, Pin Configuration, Connection Diagrams Pin Configurations D7 / D8 46, 0, 0,4x 0,3 1, - 0 M30_d 17, 6 14 2,, 6, 3,2 Pin Configuration D7 M31_e M32_e OA621.48/ D7 3NO / 1NC OA621.2/ D7 2NO / 2NC Pin Configuration D8 M3490_b OA621.48/ D8 3NO / 1NC Connection for basic grid divensions 2,0 mm as well as 2,4 mm according to DIN EN 60097, DIN EN 60326 OA 621, OA 6 D / 14.04.14 en / 430
OA 6 Dimensions, Pin Configuration, Connection Diagrams Pin Configurations D1 / D 0,3 1, - 0 0, 0,4x M3219_c 17, 2,, 6, 6, 3,2 Pin Configuration D1 M3_f 6 M36_f 6 OA 6.18/ D1 3NO / 3NC OA 6.0/ D1 2NO / 4NC M34_f 6 M33_f 6 OA 6.4/ D1 4NO / 2NC OA 6.60/ D1 NO / 1NC Pin Configuration D M3369_e 6 OA 6.60/ D NO / 1NC Connection for basic grid divensions 2,0 mm as well as 2,4 mm according to DIN EN 60097, DIN EN 60326 6 OA 621, OA 6 D / 14.04.14 en / 430
OA 6 Dimensions, Pin Configuration, Connection Diagrams Pin Configuration D7 0, 0,4x 0,3 1, - 0 M3360_d 17, 6 14 2, 3,2, 6, 6, Pin Configuration D7 M338_e 6 M339_e 6 OA 6.18/ D7 3NO / 3NC OA 6.0/ D7 2NO / 4NC 6 6 M337_e M336_e OA 6.4/ D7 4NO / 2NC OA 6.60/ D7 NO / 1NC Pin Configuration D8 6 M3491_c OA 6.48/ D8 3NO / 1NC OA 6.60/ D8 NO / 1NC Connection for basic grid divensions 2,0 mm as well as 2,4 mm according to DIN EN 60097, DIN EN 60326 7 OA 621, OA 6 D / 14.04.14 en / 430
Accessories Socket ET 141.03 3,6 6,, 49, M386_b 3,9 1,3-0 17, 8,4 27,6 Article number: 00909 Socket ET 141.037 6,, 6, 8 3,6 M370_b 3,9 1,3-0 17, 8,4 27,6 Article number: 00927 E. DOLD & SÖHNE KG D-78114 Furtwangen PO Box 121 Telephone (49) 77 23 / 64-0 Telefax (49) 77 23 / 64-36 e-mail: dold-relays@dold.com internet: http://www.dold.com 8 OA 621, OA 6 D / 14.04.14 en / 430