Material Safety Data Sheet

Transcription

1 77391-XXXX Page 1 of 5 1. Substance Identification Material/Trade Name: Stampmaker Material type: Photopolymer UV Resin Company: PhotoCentriC Ltd 12 Stevern Way Peterborough PE1 5EL Telephone: (0) Fax: (0) Emergency Tel: (0) Composition * Substance %Wt. CAS No: EC No: High Mol. Wt. Urethane XI;R36/37/38 <40 proprietary proprietary methacrylate pre-polymer Methacrylate Ester XI;R36/37/38 <30% polymer 2-Hydroxypropyl Methacrylate XI;R36-43 <10% Trethylene Glygol XI;R36/37/38 <10% Dimethacrylate Polyethylene Glycol XI;R36/37/38 <10% proprietary proprietary Methacrylate derivative Tetradecanoic acid XI;R36/37/38 <5% Acrylated oligomer XI;R36 <3% proprietary proprietary Benzophenone Derivative T;R24 XI;R36/38-43 <1% proprietary proprietary 3. Hazard Identification IRRITATING TO EYES, RESPIRATORY SYSTEM AND SKIN MAY CAUSE SENSITISATION BY SKIN CONTACT Avoid contact with skin and eyes In case of contact with eyes, rinse immediately with plenty of water and seek medical advice Wear suitable gloves 4. First-aid Measures Inhalation: Eyes: Skin: Ingestion: Remove to fresh air and rest If recovery is not rapid call for prompt medical attention Show this safety date sheet to medical personnel Irrigate with water for at least 15 minutes Take care not to wash chemical from one eye to another Get prompt medical attention Remove contaminated clothing Wash with soap/cleanser and rinse with plenty of water If irritation persists, obtain medical attention Do not induce vomiting Item Numbers: , , , Page 1 of 5

2 Give plenty of water to drink Beware of aspiration if vomiting occurs Seek medical attention immediately Page 1 of 4 Page 2 of 5 5. Fire-fighting Measures Suitable Extinguishers: Unsuitable Extinguishers: Hazardous Decomposition: Special Procedures: Alcohol resistant foam Dry powder Carbon dioxide Water fog/spray Direct water jets Toxic fumes are produced in fire Do note breathe decomposition products and fumes Use approved self-contained breathing apparatus Wear fire retardant clothing Wear eye protection Use water spray to cool containers Prevent runoff from fire control from entering waterways Large fires should only be dealt with by trained personnel 6. Accidental Release Measures Exposure Controls: Personal Protection: Disposal Considerations: Ventilate area Isolate the spillage Use barriers to prevent accidental entry into contaminated areas Do not allow spill to enter drains and watercourses Wear suitable respiratory protection e.g. EN405 FFA2 or EN140 A2 Wear polythene gloves Use eye protection such as goggles to BS EN 166 Chemical Grade Absorb in inert material such as sand or absorbent granules Scoop up and place in plastic container to await transfer Spill is classed as special waste 7. Handling and Storage Handling: Storage: Avoid skin and eye contact Avoid inhalation of vapour Ensure adequate ventilation Use local extraction equipment where possible Wear suitable protective clothing (see section 8) Store in tightly closed labelled containers Store in a cool, dry well ventilated area Item Numbers: , , , Page 2 of 5

3 Page 3 of 5 Page 2 of 4 8. Exposure Controls Occupational Exposure Limited: Not Assigned Wear polythene gloves Wear suitable overalls or apron and change if contaminated Wear suitable eye protection such as BS EN 166 Use in well ventilated areas Use mechanical ventilation if possible If excessive inhalation in a poorly ventilated area is likely then use a respirator with filter type A After contact with skin wash off immediately 9. Physical & Chemical Properties Appearance : Various coloured viscous liquids Odour : Characteristic PH : n/e Boiling point/range : n/e Melting point/range : n/e Flash point : >65 C (Closed Cup) Flammability : NON-FLAMMABLE Autoflammability : n/e Explosive properties : none Oxidising properties : none Vapour pressure : n/e Relative density : n/e Solubility : n/e Vapour Density : n/e Viscoslty : 30,000 cps Evaporation rate : n/e (Bu Ac = 1) (n/e = not established) 10. Stability and Reactivity Stable at normal temperatures Materials to avoid: oxidising agents Conditions to avoid: high temperature, sources of ignition and direct sunlight No hazardous decomposition products when stored and handled correctly 11. Toxicological Information Routes of exposure: inhalation, skin absorption and ingestion Acute effects: Profuse eye watering. Irritation of the respiratory tract and Irritation and redness at the site of skin contact Item Numbers: , , , Page 3 of 5

4 Repeated skin contact may cause sensitisation Chronic effects: Kidney and liver damage Page 3 of 4 Page 4 of Ecological Information Ecotoxicity Expected to be harmful to aquatic life Persistence: No specific information Bioaccumulative potential: No specific information Mobility: No specific Information 13. Disposal Considerations Do not discharge into drains or watercourses Dispose through property licensed contractors Dispose of in accordance with the Special Waste Regulations Transport Information 15. Regulatory Information Not classified as hazardous for transport a) Risk & Safety R36/37/38 R43 IRRITATING TO EYES, RESPIRATORY SYSTEM AND SKIN MAY CAUSE SENSITISATION BY SKIN CONTACT S24/25 Avoid contact with skin and eyes S26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice S37 Wear suitable gloves b) Other Regulations Health & Safety at Work etc. Act 1974 Control of Substances Hazardous to Health Regulations 1994 Environment Protection Act 1990 Special Waste Regulations 1996 This Safety Data Sheet is compiled with reference to The Chemical (Hazard Information and Packaging for Supply) Regulations 2000 (CHIP3), which implement the Council Directives 67/548/EEC (The Dangerous Substances Directive) and 88/379/EEC (The Dangerous Preparations Directive), and subsequent amending Item Numbers: , , , Page 4 of 5

5 Page 5 of 5 regulations, up to end including The Chemical (Hazard Information and Packaging for Supply) Regulations 2000 (CHIP2000), which implements the 26 th ATP of 67/548EEC. Page 4 of 4 Item Numbers: , , , Page 5 of 5