Material Safety Data Sheet

Transcription

1 Material Safety Data Sheet Revision Number: Issue date: 06/17/ PRODUCT AND COMPANY IDENTIFICATION Product use: Adhesive Item number: 83001_AA0300 Region: Canada Company address: Contact information: Henkel Canada Corporation Telephone: Meadowpine Boulevard Emergency telephone: Mississauga, Ontario L5N 7P2 Internet: 2. HAZARDS IDENTIFICATION EMERGENCY OVERVIEW Physical state: Liquid WHMIS hazard class: B.2, D.2.B Color: White, Opaque Odor: Sharp WARNING: Relevant routes of exposure: FLAMMABLE LIQUID AND VAPOR. CAUSES EYE, SKIN AND RESPIRATORY TRACT IRRITATION. MAY CAUSE ALLERGIC SKIN REACTION. MAY BE HARMFUL IF SWALLOWED, ABSORBED THROUGH SKIN OR INHALED. Skin, Inhalation, Eyes, Ingestion Potential Health Effects Inhalation: Skin contact: Eye contact: Ingestion: Existing conditions aggravated by exposure: Vapors may cause headaches, nausea, dizziness and respiratory tract irritation. May be harmful if inhaled. Causes skin irritation. May cause allergic skin reaction. May be harmful if absorbed through skin. Vapors may irritate eyes. Contact with eyes will cause irritation. May cause gastrointestinal tract irritation if swallowed. May be harmful if swallowed. Eye, skin, and respiratory disorders. See Section 11 for additional toxicological information. 3. COMPOSITION / INFORMATION ON INGREDIENTS Hazardous components CAS NUMBER % Methyl methacrylate Polyethylene based rubber Proprietary Nepheline syenite Methacrylic acid Butyl hydroxytoluene Talc FIRST AID MEASURES Inhalation: Move to fresh air. If breathing is difficult, give oxygen. If not breathing, give artificial respiration. If symptoms develop and persist, get medical attention. Page 1 of 5

2 Skin contact: Eye contact: Ingestion: Immediately flush skin with plenty of water (using soap, if available). Remove contaminated clothing and footwear. If symptoms develop and persist, get medical attention. Wash clothing before reuse. Thoroughly clean shoes before reuse. Flush with copious amounts of water, preferably, lukewarm water for at least 15 minutes, holding eyelids open all the time. Get medical attention. DO NOT induce vomiting unless directed to do so by medical personnel. Never give anything by mouth to an unconscious person. Get medical attention. 5. FIRE FIGHTING MEASURES Flash point: Autoignition temperature: Flammable/Explosive limits - lower: Flammable/Explosive limits - upper: Extinguishing media: Special firefighting procedures: Unusual fire or explosion hazards: Hazardous combustion products: Sensitivity to Mechanical Impact: Sensitivity to static discharge: 14 C (57.2 F) Setaflash Closed Cup Foam, dry chemical or carbon dioxide. Wear self-contained breathing apparatus and full protective clothing, such as turn-out gear. Vapors may accumulate in low or confined areas, travel considerable distance to source of ignition, and flash back. Oxides of carbon. Oxides of nitrogen. Aldehydes. Alcohols. Hydrogen chloride. Oxides of sulfur. Organic acids. Toxic and irritating vapors. Cumene. Carbon tetrachloride. 6. ACCIDENTAL RELEASE MEASURES Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected personnel. Environmental precautions: Clean-up methods: Do not allow product to enter sewer or waterways. Remove all sources of ignition. Ensure adequate ventilation. Wear appropriate personal protective equipment. Soak up with inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust). Store in a partly filled, closed container until disposal. 7. HANDLING AND STORAGE Handling: Storage: Do not taste or swallow. Prevent contact with eyes, skin and clothing. Do not breathe vapor and mist. Wash thoroughly after handling. During use and until all vapors are gone: Keep area ventilated - do not smoke; extinguish all flames, pilot lights, and heaters; turn off stoves, electrical tools and appliances, and any other sources of ignition. Make sure containers are properly grounded before use or transfer of material. Keep container closed. For safe storage, store at or below 32 C (89.6 F) Keep away from heat, spark and flame. Keep container tightly closed and in a cool, well-ventilated place away from incompatible materials. For information on product shelf life contact Henkel Canada Customer Service at (905) Page 2 of 5

3 8. EXPOSURE CONTROLS / PERSONAL PROTECTION Employers should complete an assessment of all workplaces to determine the need for, and selection of, proper exposure controls and protective equipment for each task performed. Hazardous components ACGIH TLV OSHA PEL AIHA WEEL OTHER Methyl methacrylate 50 ppm TWA 100 ppm STEL (Sensitizer.) 100 ppm (410 mg/m3) TWA 50 ppm Polyethylene based rubber Nepheline syenite Methacrylic acid 20 ppm TWA Butyl hydroxytoluene Talc 2 mg/m3 TWA Inhalable fraction and vapor. 2 mg/m3 TWA Respirable fraction. 20 MPPCF TWA 2.4 MPPCF TWA Respirable. 0.1 mg/m3 TWA Respirable. 0.3 mg/m3 TWA Total dust. 50 ppm Engineering controls: Respiratory protection: Eye/face protection: Skin protection: Use local ventilation if general ventilation is insufficient to maintain vapor concentration below established exposure limits. Use NIOSH approved respirator if there is potential to exceed exposure limit(s). Safety goggles or safety glasses with side shields. Use chemical resistant, impermeable clothing including gloves and either an apron or body suit to prevent skin contact. Nitrile gloves. 9. PHYSICAL AND CHEMICAL PROPERTIES Physical state: Liquid Color: White, Opaque Odor: Sharp Odor threshold: ph: Vapor pressure: 28 mm hg (20 C (68 F)) Boiling point/range: > 100 C (> 212 F) Melting point/ range: Specific gravity: 1.06 Vapor density: > 1 Flash point: 14 C (57.2 F) Setaflash Closed Cup Flammable/Explosive limits - lower: Flammable/Explosive limits - upper: Autoignition temperature: Evaporation rate: Faster than ether. Solubility in water: Slight Partition coefficient (n-octanol/water): VOC content: 9.01 %; 95.5 g/l (Adhesive and Activator mixed) Page 3 of 5

4 10. STABILITY AND REACTIVITY Stability: Hazardous reactions: Hazardous decomposition products: Incompatible materials: Conditions to avoid: Stable under normal conditions of storage and use. Polymerization may occur at elevated temperatures or upon depletion of inhibitor. Irritating organic vapours. Oxidizing agents. Reducing agents. Acids. Bases. Alkali metals. See "Handling and Storage" (Section 7) and "Incompatibility" (Section 10). Do not mix in batches greater than 100 grams (0.22 pounds) unless you plan to use immediately. 11. TOXICOLOGICAL INFORMATION Toxicologically synergistic products: Refer to the following for Irritancy of Product, Sensitization to Product, Carcinogenicity, Reproductive Toxicity, Teratogenicity, and Mutagenicity. Hazardous components NTP Carcinogen IARC Carcinogen OSHA Carcinogen (Specifically Regulated) ACGIH Carcinogen Methyl methacrylate No No No Group A4 Polyethylene based rubber No No No No Nepheline syenite No No No No Methacrylic acid No No No No Butyl hydroxytoluene No No No Group A4 Talc No No No Group A4 Hazardous components LD50s and LC50s Health Effects/Target Organs Methyl methacrylate Oral LD50 (RAT) = 9,400 mg/kg Oral LD50 (RAT) = 7,800 mg/kg Oral LD50 (rabbit) = 6,000 mg/kg Inhalation LC50 (RAT, 8 h) = 3,750 mg/l Allergen, Irritant, Kidney, Liver, Mutagen, Nervous System, Respiratory Polyethylene based rubber Nepheline syenite No Target Organs No Target Organs Methacrylic acid Oral LD50 (RAT) = 1,600 mg/kg Oral LD50 (RAT) = 1,060 mg/kg Oral LD50 (rabbit) = 1,200 mg/kg Dermal LD50 (rabbit) = 500 mg/kg Inhalation LC50 (RAT, 4 h) = 7.1 mg/l Corrosive, Irritant, Allergen Butyl hydroxytoluene Oral LD50 (RAT) = 890 mg/kg Irritant, Mutagen Talc 12. ECOLOGICAL INFORMATION Irritant, Lung, Some evidence of carcinogenicity Ecological information: Page 4 of 5

5 13. DISPOSAL CONSIDERATIONS Information provided is for unused product only. Recommended method of disposal: Follow all local, state, federal and provincial regulations for disposal. 14. TRANSPORT INFORMATION Canada Transportation of Dangerous Goods - Ground ADHESIVES Exceptions: May qualify as a Consumer Commodity or Limited Quantity. Refer to TDG regulations. International Air Transportation (ICAO/IATA) Adhesives Exceptions: May Qualify as Consumer Commodity, ID8000, (Not more than 500 ml) Water Transportation (IMO/IMDG) ADHESIVES Canada Regulatory Information 15. REGULATORY INFORMATION CEPA DSL/NDSL Status: All components are listed on or are exempt from listing on the Canadian Domestic Substances List. United States Regulatory Information TSCA 8 (b) Inventory Status: All components are listed or are exempt from listing on the Toxic Substances Control Act Inventory. 16. OTHER INFORMATION This material safety data sheet contains changes from the previous version in sections: New Material Safety Data Sheet format. 2, 4, 5, 7, 10, 14, 15 This product has been classified in accordance with the hazard criteria of the Controlled Products Regulation (CPR), and the MSDS contains all the information required by the CPR. Prepared by: Rena Petrides, Regulatory Affairs Specialist DISCLAIMER: The data contained herein are furnished for information only and are believed to be reliable. However, Henkel Corporation does not assume responsibility for any results obtained by persons over whose methods Henkel Corporation has no control. It is the user's responsibility to determine the suitability of Henkel's products or any production methods mentioned herein for a particular purpose, and to adopt such precautions as may be advisable for the protection of property and persons against any hazards that may be involved in the handling and use of any of Henkel Corporation's products. In light of the foregoing, Henkel Corporation specifically disclaims all warranties, express or implied, including warranties of merchantability and fitness for a particular purpose, arising from sale or use of Henkel Corporation's products. Henkel Corporation further disclaims any liability for consequential or incidental damages of any kind, including lost profits. Page 5 of 5