QUICK START GUIDE SENTIERO HANDHELD OAE AND AUDIOMETRY SCREENER (GREEN LABEL)

Transcription

1 TURNING ON/OFF, CHARGING THE DEVICE On/off button on right side Power supply connector START MENU Current time Battery status Select patient Customize settings Turn off device TESTING Additional information on options for current screen AUDIOMETRY Connect the headphones to the blue connector. Select the Audiometry: Screening button from the start menu. Select the ear on which you want to start the test. Page 1 of 6

2 AUDIOMETRY TEST SCREEN Stimulus on indicator Select the stimulus levels Select the frequency Press to present the stimulus Stop test Additional information about options for current screen Select the ear to test Select the type of stimulus: pure tone pulsed tone or warble As you present the stimulus, the current level will be displayed on the corresponding (yellow) square. Once the hearing status for a frequency has been identified, move on to the next frequency. Tapping twice on a square will display NR (no response). Tap three times to get back to a blank square. Once all frequencies have been tested for one ear, you can test the other ear. Page 2 of 6

3 When the test is finished, press the Stop button. You can add the patient s personal data, and save on the device, print to a label (a label printer is required) or print to a pdf file or full page report on PC. DISTORTION PRODUCT OTOACUSTIC EMISSIONS (DPOAE) SCREENING Connect the probe to the red connector. Select either the Screening or the Standard button from the start menu. Select the appropriate ear tip size and place it on the probe tip. Insert the probe in the ear making sure that the ear tip fits tightly into the ear canal. Select the test ear by pressing either the Right or Left button. Select balloon mode to show balloons when the test is finished. Page 3 of 6

4 A calibration will be performed prior to measurement. A green light indicates successful calibration (see below left). After successful ear probe calibration, the test will start automatically. Probe fit override for patients with PE tubes or middle ear perforation Progress for each tested frequency Overall test progress Noise floor level DPOAE TEST RESULTS RESULTS VIEW (Simple) Please note that the initial result screen depends on the module settings in "DPOAE Preferences" If the required criteria were met, the result will be PASS. If not, it will be REFER. Test other ear Print results to a label or to a pdf file or full page report on PC. Re-test failed frequencies Note: These circles indicate that other screens are available to view. Swipe your finger right or left to get other views. Switch to results of the other ear after both ears have been tested Page 4 of 6

5 DETAILED RESULTS VIEW Red or blue bars indicate response, grey bars indicate noise Outcome for each test sorted by f2 and L2 Numeric values shown in table format Page 5 of 6

6 Quick Guide Information Release date: Revision: 02 Valid from: Firmware Rev. 2.1, Mira PC Software Rev Applies to: Model: SOH100098, web description SOH01 All mentioned items, products, brands and trademarks are registered or owned by the mentioned companies. All information, illustrations, and specifications provided within this manual are based on the latest product information available at the time of publication. PATH medical reserves the right to make changes at any time without notice. Please note that not all products displayed on our webpage or advertising materials are available in all territories. Please contact your local distributor or PATH medical for further information. The latest revision of the Quick Start Guide is available online at Errors and omissions excepted. Copyright Notice No part of this manual may be reproduced, translated, stored, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written consent of PATH medical GmbH. Copyright 2016 PATH medical GmbH PATH medical GmbH Landsberger Straße Germering Germany Tel.: Fax: Internet: Page 6 of 6