PHAR 7633 Chapter 20 Non Compartmental Analysis

Transcription

1 Student Objectives for this Chapter PHAR 7633 Chapter 20 Non Compartmental Analysis To understand and use the non compartmental approach to parameter estimation be able to define, use, and calculate the parameters: AUMC (area under the first moment curve) MRT (mean residence time) MAT (mean absorption time) MDT (mean dissolution time) Non Compartmental Analysis Non compartmental methods can be used to determine certain pharmacokinetic parameters without deciding on a particular compartmental model. The basic calculations are based on the area under the plasma concentration versus times curve (zero moment) and the first moment curve (AUMC). The AUC can be calculated as before using the trapezoidal rule. The first moment is calculated as concentration times time (Cp t). The AUMC is the area under the concentration times time versus time curve. Maybe best covered with an example. Consider a drug given both by IV and oral administration. Both the AUC and AUMC were calculated using the trapezoidal rule without making any assumption concerning the number of compartments. The final segment of the AUC curve is calculated as Cp(last)/k', where k' is the last exponential term (the slowest) calculated from the Cp versus time graph. The last segment for the AUMC curve is: Equation Equation of the last segment AUMC Page 1 of 8

2 Time (hr) Cp (mg/l) Cp t (mg.hr/l) AUC (mg.hr/l) AUMC (mg.hr 2 /L) Table Typical Cp versus Time Data after 100 mg IV Bolus Administration These data, Cp versus time and Cp x time versus time, can be plotted on linear graph. Page 2 of 8

3 Figure Plot of Cp versus Time (IV) and various parameters can be calculated as: Figure Plot of Cp x Time versus Time (IV) Equation Equation for Mean Residence Time (MRT) Equation Equation for Apparent Elimination Rate constant (kel') Page 3 of 8

4 Equation Equation for Total Body Clearance (TBC) Equation Equation for Apparent Volume of Distribution, Steady State (V ss ) From the AUC and AUMC values we can calculate the mean residence time, MRT. This is the average time that the drug stays in the body (or plasma as measured here). It can be related to the average elimination rate constant as 1/MRT. The values from the above data are MRT = /67.27 = 8.17 hr and kel' = 1/8.17 = 0.12 hr -1 Remember we can also calculate the clearance, CL = Dose/AUC = 100/67.27 = 1.49 L.hr -1 Finally a steady state volume can be calculated as V ss = CL MRT = 1.49 x 8.17 = L Page 4 of 8

5 Oral data can be analyzed by these methods as well. Time (hr) Cp (mg/l) Cp t (mg.hr/l) AUC (mg.hr/l) AUMC (mg.hr 2 /L) Table Typical Cp versus Time Data after 250 mg Oral Administration These data, Cp versus time and Cp x time versus time, can be plotted on linear graph. Figure Plot of Cp versus Time (PO) Page 5 of 8

6 Figure Plot of Cp x Time versus Time (PO) and additional parameters can be calculated (NOTE: We don't calculate Clearance or V ss using oral data). Equation Equation for Mean Absorption Time (MAT) Equation Equation for Apparent Absorption Rate Constant (ka') Equation Equation for Oral Bioavailability (F) The data were calculated after a 250 mg oral dose of the same drug. From these data a MRT was calculated as MRT = AUMC/AUC = 1361/149.8 = 9.08 hr We can subtract from this MRT(PO) the MRT(IV) to get an idea of the absorption process, the mean absorption time (MAT). That is MAT = MRT(PO) - MRT(IV) = = 0.92 hr From this we can calculate an average absorption rate constant ka' = 1/MAT = 1/0.92 = 1.09 hr -1 Of course we can calculate the bioavailability of the oral dosage form using the dose adjusted AUC ratio. Thus F = (149.70/67.27) x (100/250) = 0.89 Page 6 of 8

7 Another Example using Data from Bevill et al Pharmacokinetics of Sulfamethazine in Cattle following IV and Three Oral Dosage Forms Dosage Forms IV Bolus 107 mg/kg Oral Solution 107 mg/kg Oral Rapid Release Tablet 105 mg/kg Oral Sustained Release Tablet 249 mg/kg Figure The Average Data from Each Dosage Form AUC AUMC MRT (hr) MAT (hr) MDT (hr) IV Solution Tablet Slow Tablet Table Non Compartmental Analysis Results Rate Constant (hr -1 ) Non Linear Regression Analysis Non Compartmental Analysis kel' ka' kd' (fast) kd' (slow) Table Comparison with Non Linear Regression Analysis (SAAM) Page 7 of 8

8 Non compartmental analysis: kel' = 1/MRT ka' = 1/MAT kd' = 1/MDT where MDT is the mean dissolution time Want more practice with this type of problem! References Bevill, R.F., Dittert, L.W. and Bourne, D.W.A Pharmacokinetics of Sulfamethazine in Cattle following IV and Three Oral Dosage Forms, J. Pharm. Sci., 66, This page ( was last modified: Wednesday 26 May 2010 at 09:00 AM Material on this website should be used for Educational or Self-Study Purposes Only Copyright David W. A. Bourne (david@boomer.org) Page 8 of 8