Robotics, Laparoscopy & Endosurgery

Transcription

1 Robotics, Laparoscopy and Endosurgery Robotics, Laparoscopy & Endosurgery How to preserve bladder neck during robotic radical prostatectomy? Abdullah Erdem Canda* Department of Urology, Yildirim Beyazit University, School of Medicine, Ankara Ataturk Training & Research Hospital, Ankara, Turkey *Dr. Canda is a board member European Association of Urology (EAU) Robotic Urology Section (ERUS) Video Article Point of Technique Abstract Preservation of the bladder neck is an important step during performing robot-assisted laparoscopic radical prostatectomy (RARP). Removal of periprostatic fat tissue leads to a better exposure of the bladder neck and prostatic junction. It is important not to use too much cautery and not to enter a deeper plane initially that could lead to damaging bladder neck and the surrounding tissues thus disrupt the normal anatomy. When the bladder neck is seen, bipolar forceps is used on both sides of it in order to isolate it. Following exposure of the bladder neck, monopolar scissors is used on both sides in order to dissect the plane between the bladder and the prostate. For obtaining a bladder neck with a maximum length, prostate is pushed forward before cutting it. Bladder neck and urethra is cut close to the prostate without using any cautery application. Bladder neck preservation is easy to perform in small prostates without a median lobe or prostates without previous TURP/prostate surgery history. Preserving bladder neck facilitates the anastomosis between urethra and bladder neck following completion of RARP and might provide decreased postoperative cystographic leakage, early removal of urethral catheter and early recovery of urinary continence. Key Words: Bladder neck sparing, Robotic surgery, Prostate cancer Video of this article can be accessed on Radical prostatectomy provides long-term cancer control in patients with localized prostate cancer (1). Robot-assisted laparoscopic radical prostatectomy (RARP) has increasingly become a preferred treatment of choice both by patients and urologists since its introduction in 2001 (2). We previously published outcomes of our experience in performing RARP (3,4). In the article, surgical technique of bladder neck preservation during RARP is explained. Patient positioning A transperitoneal approach is used patient in the steep (30 ) Trendelenburg position (Figure 1). Abdominal port placement A total of 5 abdominal ports are placed, four 8 mm sized robotic trocars for robotic instruments and for 3D-HD camera and a 12 mm sized trocar for bedside assistance. Da Vinci Xi Surgical System (Intuitive Surgical, Sunnyvale, CA, USA) is used (Figure 2). Maryland bipolar forceps is used on the left side of the umbilicus. Whereas, monopolar curved scissors (Hot Shears TM ) and Prograsp TM forceps are used on the right side of the umbilicus. In addition, a large needle driver is also used on the right side of the umbilicus. A 0 o lens is used in most of the procedure Received : 06 January 2016 Accepted : 07 February 2016 Correspondence Address Abdullah Erdem Canda Yildirim Beyazit University, School of Medicine, Ankara Ataturk Training & Research Hospital, Department of Urology, Bilkent Ankara, Turkey Phone: erdemcanda@yahoo.com

2 How to Preserve Bladder Neck During Robotic Radical Prostatectomy? Figure 1: Patient position during RARP. Figure 2: Abdominal port sites during RARP. TIPS AND TRICKS IN IDENTIFICATION AND ISOLATION OF THE BLADDER NECK II. Using 4th-arm in order to retract the bladder posteriorly I. Removal of periprostatic fat tissue Bladder is retracted posteriorly with 4th-robotic arm holding the Prograsp forceps and this manoeuvre shows the intersection point of bladder neck and the prostate (Figure 4). Removal of periprostatic fat tissue leads to a better exposure of the bladder neck and the junction between prostate and bladder neck. Therefore, the author suggest that the surgeon spends some time during surgery in order to excise and remove all the periprostatic fat which is one of the crucial steps of bladder neck preservation (Figure 3). When the periprostatic fat tissue is excised, the surgeon better identifies the anatomical structures. Figure 3: Removal of periprostatic fat tissue during RARP. III. Dissecting bladder neck Monopolar scissors is used in order to dissect the superficial tissues overlying the bladder neck and during this dissection bipolar forceps on the left hand is used in order to further retract the bladder posteriorly that clearly shows the anatomy (Figure 5). Small bleeders could be cauterized to obtain a clear vision. It is important not to use the cautery too much and not to enter a deeper plane initially that could cause a charring effect on the tissues thus disrupt and damage the normal anatomy. Figure 4: Using 4th-arm in order to retract the bladder posteriorly. 71

3 Canda AE Bipolar forceps on the left hand is used in order to further dissect the tissues surrounding the bladder neck as if using a right angle forceps during performing open surgery (Figure 6). This manoeuvre is very helpful in isolation and exposure of the bladder neck. When the bladder neck is seen, bipolar forceps is used on both sides of the bladder neck in order to completely isolate it. For a better exposure, the 4th-arm further retracts the bladder posteriorly that elongates the bladder neck. When the bladder neck is exposed, monopolar scissors is used on both sides of the bladder neck in order to enter the plane between the bladder and the prostate (Figure 7). The assistant surgeon pulls the urethral catheter back and forth that nicely shows and exposes the bladder neck and the urethra (Figure 8). In addition, assistant surgeon aspirates smoke and clears any bleeding during the dissection that provides a nice vision for the operating console surgeon. In order to obtain a maximum length of bladder neck, prostate is pushed forward before cutting (Figure 9). Cauterization of the bladder neck is avoided in order to prevent thermal injury that could have a negative impact on postoperative urinary continence. Following obtaining a bladder neck with a maximal length, bipolar forceps is passed under it (Figure 10). Thereafter, bladder neck and urethra is cut close to the prostate without using any cautery application (Figures 10 and 11). Following appearance of the urethra Foley catheter, assistant surgeon Figure 5: Using monopolar scissors in order to dissect the superficial tissues covering the bladder neck. Figure 6: Using bipolar forceps in order to isolate the bladder neck. Figure 7: Dissecting the plane between the prostate and the bladder. Figure 8: Exposing the bladder neck and the urethra. 72

4 How to Preserve Bladder Neck During Robotic Radical Prostatectomy? Figure 9: Obtaining a prolonged bladder neck. Figure 10: Cutting the bladder neck. TAKE HOME MESSAGES 1. Removal of periprostatic fat tissue leads to a better exposure of the bladder neck. It is important not to use the cautery too much and not to enter a deeper plane that could lead to damaging the bladder neck and disruption of the surrounding tissues that could damage the normal anatomy. 2. When the bladder neck is seen, bipolar forceps is used on both sides of the bladder neck in order to isolate it. For a maximum length of bladder neck, prostate is pushed forward before cutting. 3. Bladder neck and urethra is cut close to the prostate without using any cautery application. Figure 11: Cutting the bladder neck. withdraws the catheter. Lastly, the posterior part of the bladder neck is cut and bladder neck is completely separated from the prostate. Thereafter, the plane between the bladder neck and prostate is further dissected, seminal vesicles and vas deferences are identified. The other steps follow in order to complete the RARP procedure. Previously, other authors presented their technique of bladder neck preservation during RARP (5,6). Bladder neck preservation is easy to perform in small prostates without a median lobe or prostates without previous TURP/ prostate surgery history. Preserving bladder neck might provide decreased postoperative cystographic leakage, early removal of urethral catheter and early recovery of urinary continence. 4. Bladder neck preservation is easy to perform in small prostates without a median lobe or prostates without previous TURP/prostate surgery history. 5. Preserving bladder neck facilitates the anastomosis between the bladder neck and the urethra and might provide decreased postoperative cystographic leakage, early removal of urethral catheter and early recovery of urinary continence. References 1. Roehl KA, Han M, Ramos CG, Antenor JA, Catalona WJ. Cancer progression and survival rates following anatomic radical retropubic prostatectomy in 3,478 consecutive patients: longterm results. J Urol 2004; 172: Badani KK, Kaul S, Menon M. Evolution of robotic radical prostatectomy: assessment after 2766 procedures. Cancer 2007; 110:

5 Canda AE 3. Canda AE, Atmaca AF, Akbulut Z, Asil E, Kilic M, Isgoren E, Balbay MD. Results of robotic radical prostatectomy in the hands of surgeons without previous laparoscopic radical prostatectomy experience. Turkish Journal of Medical Sciences 2012;42(Suppl 1): Tasci AI, Tufek I, Gumus E, Canda AE, Tugcu V, Atug F, Boylu U, Akbulut Z, Sahin S, Simsek A, Kural AR. Oncologic results, functional outcomes, and complication rates of robotic-assisted radical prostatectomy: multicenter experience in Turkey including 1,499 patients. World J Urol Aug;33(8): Akin Y, Tunc L. Is It Just Enough to Keep Long Membranous Urethra for Providing Early Continence After Robot-Assisted Laparoscopic Radical Prostatectomy? J Endourol Jan 7. [Epub ahead of print] 6. Dal Moro F. Athermal bladder neck dissection during robotassisted radical prostatectomy. Int Braz J Urol May- Jun;40(3):433; discussion 434. doi: /S IBJU