The Flint Lock: A Novel Technique in Total Knee Arthroplasty Closure

Transcription

1 The Flint Lock: A Novel Technique in Total Knee Arthroplasty Closure Publish date: September 13, 2018 Authors: Jeffrey B. Peck, MD Paul M. Charpentier, MD Sherry K. Bowman, ANP-BC Ajay K. Srivastava, MD Author Affiliation Disclosures Authors Disclosure Statement: The authors report no actual or potential conflict of interest in relation to this article. Dr. Peck is an Orthopedic Surgery Fellow, Hospital for Special Surgery, New York, New York. Dr. Charpentier is an Orthopedic Surgeon, Howard Memorial Hospital, Willits, California. Dr. Srivastava is Associate Professor, Department of Orthopedic Surgery, McLaren-Flint/Michigan State University, Flint, Michigan. Ms. Bowman is a Nurse Practitioner, Department of Orthopedic Surgery, Hurley Medical Center, Flint, Michigan. Address correspondence to: Jeffrey B. Peck, MD, Center of Hip Preservation, Hospital for Special Surgery, 535 E. 70th St, New York, NY (tel, ; fax, ; , JeffreyPeck2007@u.northwestern.edu). Am J Orthop. 2018;47(9). Copyright Frontline Medical Communications Inc All rights reserved. Take-Home Points The Flint Lock is a novel technique in TKA closure. Its continuous nature provides a tight seal with extensor mechanism closure. The utilization of a segmental closure with double suture provides a safeguard for suture failure. The suture used in the technique is less expensive than barbed suture. Future investigation is warranted to further validate the use of the Flint Lock. In 2003, more than 400,000 total knee replacements were performed in the United States. This number is expected to increase in the coming decades to 3 million by the year The surgical approach to knee arthroplasty always involves a capsular incision that needs to be repaired after implantation of the components. The capsular incision repair should be strong enough to allow for immediate range of motion. Traditionally, repair of the arthrotomy is performed using interrupted sutures. Recently, a running technique using barbed suture has been demonstrated to enable faster closure times.2-6 In addition, a running suture technique using barbed suture provides a superior watertight closure compared with an interrupted suture.7 It has been reported that the barbed suture has the same safety profile as that of interrupted sutures,2,3,4 although extensor mechanism repair failure8 and wound complications9,10 have been reported. This study proposes a novel technique for arthrotomy closure in total knee arthroplasty (TKA). It is a double continuous interlocking stitch, termed the Flint Lock. Based on our clinical experience using this method, this 1

2 technique has been found to be safe and effective. Technique The Flint Lock was developed for closure in TKA, which was performed through a standard medial parapatellar approach. Before creating the arthrotomy, a horizontal line is drawn along the medial side of the patella to ensure anatomic alignment of the extensor mechanism during closure of the capsule. The Flint Lock is performed by 2 people working simultaneously. Closure begins at the proximal end of the arthrotomy using 2 No. 1 Vicryl (Ethicon) sutures. Each suture is thrown a single time at the most proximal extent of the arthrotomy with the knee in 30 to 40 of flexion. These sutures are tied off independently from each other (Figure 1). At this point, the knee is flexed to 90 and the sutures are thrown alternately, with the first operator passing medial to lateral through the capsule and the second operator passing lateral to medial. While 1 operator is passing a suture, the other operator holds the other suture tight to maintain tension on the closure. The alternating throws create an interlocking weave as the pattern is repeated and progressively moves distally (Figure 2). This technique results in 2 continuous sutures running in opposing directions. Each No. 1 Vicryl suture is specific to each operator. Therefore, each operator uses the same suture for the entirety of the closure. When the superior pole of the patella is reached, the 2 sutures are tied together, thus creating a segmental closure (Figure 3). Following this tie off, the closure is continued in a similar manner until the inferior pole of the patella is reached. The sutures are then tied off to each other again, creating another segmental closure (Figure 4). The remainder of the arthrotomy is closed continuing the Flint Lock technique, and the 2 sutures are tied off to each other at the distal end of the arthrotomy and cut (Figure 5). The superficial layers are closed at the surgeon s discretion. The authors prefer interrupted 2-0 Vicryl sutures followed by a running 3-0 Monocryl (Ethicon) suture in the subcutaneous layer. Dermabond (Ethicon) skin glue and an Aquacel Ag (ConvaTec) dressing are applied, followed by a compressive bandage. Discussion The importance of a strong, tight closure of the arthrotomy in TKA is critical to the success of the procedure. Nevertheless, there are multiple methods to achieve closure. The Flint Lock technique is a novel method that employs basic concepts of surgical technique in an original manner. The continuous nature of the closure should provide a tighter seal, leading to less wound drainage. Persistent wound drainage has been associated with deep wound infections following total joint arthroplasty.11,12 In addition, the double suture provides a safeguard to a single suture rupture, while the segmental quality protects against complete arthrotomy failure. A potential downside of this technique is that it requires 2 individuals operating 2 needles simultaneously. This presents a potential for a sharp injury to the operators; however, this has not occurred in our experience. A comparable risk with interrupted sutures is probably present because there are often multiple sutures utilized during closure via the interrupted technique. In 2015, the cost of a single No. 1 barbed suture was $13.14 at our institution, whereas the cost of 2 No. 1 Vicryl sutures was $3.66. Although pricing differs across hospitals, the Vicryl sutures are probably less costly compared with the barbed sutures. Our experience with the Flint Lock technique has been favorable thus far, with no incidences of postoperative 2

3 drainage, infection, or extensor mechanism failure. Our current use has been in closure of the knee, but it could be considered in closure of long incisions about the hip as well. A more in-depth analysis of relevant factors, such as time for closure, mechanical strength, cost savings, and clinical outcomes, is needed to further evaluate this method of closure. In addition, biomechanical analysis of the technique would aid in its evaluation. Future studies are needed to analyze these factors to verify the benefits and viability of the Flint Lock technique. Key Info Figures/Tables Figures / Tables: peck0918_f1.jpg 3

4 peck0918_f2.jpg 4

5 peck0918_f3.jpg 5

6 peck0918_f4.jpg 6

7 peck0918_f5.jpg 7

8 References References References 1. Kurtz S, Ong K, Lau E, Mowat F, Halpern M. Projections of primary and revision hip and knee 8

9 arthroplasty in the United States from 2005 to J Bone Joint Surg Am. 2007;89(4): doi: /jbjs.f Eickmann T, Quane E. Total knee arthroplasty closure with barbed sutures. J Knee Surg. 2010;23(3): doi: /s Gililland JM, Anderson LA, Sun G, Erickson JA, Peters CL. Perioperative closure-related complication rates and cost analysis of barbed suture for closure in TKA. Clin Orthop Relat Res. 2012;470(1): doi: /s Ting NT, Moric MM, Della Valle CJ, Levine BR. Use of knotless suture for closure of total hip and knee arthroplasties: a prospective, randomized clinical trial. J Arthroplasty. 2012;27(10): doi: /j.arth Stephens S, Politi J, Taylor BC. Evaluation of primary total knee arthroplasty incision closure with use of continuous bidirectional barbed suture. Surg Technol Int. 2011;21: Levine BR, Ting N, Della Valle CJ. Use of a barbed suture in the closure of hip and knee arthroplasty wounds. Orthopedics. 2011;34(9):e473-e475. doi: / Nett M, Avelar R, Sheehan M, Cushner F. Water-tight knee arthrotomy closure: comparison of a novel single bidirectional barbed self-retaining running suture versus conventional interrupted sutures. J Knee Surg. 2011;24(1): doi: /s Wright RC, Gillis CT, Yacoubian SV, Raven RB 3rd, Falkinstein Y, Yacoubian SV. Extensor mechanism repair failure with use of birectional barbed suture in total knee arthroplasty. J Arthroplasty. 2012;27(7):1413.e1-e4. doi: /j.arth Campbell AL, Patrick DA Jr, Liabaud B, Geller JA. Superficial wound closure complications with barbed sutures following knee arthroplasty. J Arthroplasty. 2014;29(5): doi: /j.arth Smith EL, DiSegna ST, Shukla PY, Matzkin EG. Barbed versus traditional sutures: closure time, cost, and wound related outcomes in total joint arthroplasty. J Arthroplasty. 2014;29(2): doi: /j.arth Saleh K, Olson M, Resig S, et al. Predictors of wound infection in hip and knee joint replacement: results from a 20 year surveillance program. J Orthop Res. 2002;20(3): doi: /s (01)00153-x. 12. Weiss AP, Krackow KA. Persistent wound drainage after primary total knee arthroplasty. J Arthroplasty. 1993;8(3): doi: /s (06) Multimedia 9

10 Product Guide Product Guide STRATAFIX Symmetric PDS Plus Knotless Tissue Control Device STRATAFIX Spiral Knotless Tissue Control Device BioComposite SwiveLock Anchor BioComposite SwiveLock C, with White/Black TigerTape Loop Citation Jeffrey B. Peck, MD Paul M. Charpentier, MD Sherry K. Bowman, ANP-BC Ajay K. Srivastava, MD. The Flint Lock: A Novel Technique in Total Knee Arthroplasty Closure. Am J Orthop. Publish date: September 13, 2018 Jeffrey B. Peck, MD 10