SAFETY DATA SHEET. Not classified. Skin corrosion/irritation Serious eye damage/eye irritation

Transcription

1 SAFETY DATA SHEET 1. Identification Product identifier Other means of identification SKU# Recommended use Recommended restrictions Escoweld 7505E Hardener GP115H ne known. Manufacturer/Importer/Supplier/Distributor information Manufacturer Company name ITW Engineered Polymers Address 130 Commerce Drive Montgomeryville, PA Telephone United States Customer Service (215) Website Contact person EHS Department Emergency phone number CHEMTREC (800) International (703) Hazard(s) identification Physical hazards Health hazards Environmental hazards OSHA defined hazards Label elements t classified. Skin corrosion/irritation Serious eye damage/eye irritation Sensitization, skin t classified. t classified. Category 2 Category 2 Category 1 Signal word Hazard statement Prevention Response Storage Disposal Hazard(s) not otherwise classified (HNOC) Supplemental information Warning Causes skin irritation. May cause an allergic skin reaction. Causes serious eye irritation. Avoid breathing mist or vapor. Wash thoroughly after handling. Contaminated work clothing must not be allowed out of the workplace. Wear protective gloves. Wear eye/face protection. If on skin: Wash with plenty of water. If inhaled: Remove person to fresh air and keep comfortable for breathing. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If skin irritation or rash occurs: Get medical advice/attention. If eye irritation persists: Get medical advice/attention. Take off contaminated clothing and wash before reuse. Store away from incompatible materials. Dispose of contents/container in accordance with local/regional/national/international regulations. ne known. t applicable. 3. Composition/information on ingredients Mixtures Chemical name Common name and synonyms CAS number % Amidoamine N/A *Designates that a specific chemical identity and/or percentage of composition has been withheld as a trade secret. 1 / 6

2 4. First-aid measures Inhalation Skin contact Eye contact Ingestion Most important symptoms/effects, acute and delayed Indication of immediate medical attention and special treatment needed General information 5. Fire-fighting measures Suitable extinguishing media Unsuitable extinguishing media Specific hazards arising from the chemical Special protective equipment and precautions for firefighters Fire-fighting equipment/instructions Specific methods General fire hazards Move to fresh air. Call a physician if symptoms develop or persist. Remove contaminated clothing immediately and wash skin with soap and water. In case of eczema or other skin disorders: Seek medical attention and take along these instructions. Take off contaminated clothing and wash before reuse. Immediately flush eyes with plenty of water for at least 15 minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Get medical attention if irritation develops and persists. Rinse mouth. Get medical attention if symptoms occur. Symptoms may include stinging, tearing, redness, swelling, and blurred vision. May cause an allergic skin reaction. Dermatitis. Rash. May cause redness and pain. Provide general supportive measures and treat symptomatically. Keep victim under observation. Symptoms may be delayed. Ensure that medical personnel are aware of the material(s) involved, and take precautions to protect themselves. Wash contaminated clothing before reuse. Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2). Do not use water jet as an extinguisher, as this will spread the fire. During fire, gases hazardous to health may be formed. Self-contained breathing apparatus and full protective clothing must be worn in case of fire. Move containers from fire area if you can do so without risk. Move containers from fire area if you can do so without risk. unusual fire or explosion hazards noted. 6. Accidental release measures Personal precautions, protective equipment and emergency procedures Methods and materials for containment and cleaning up Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Wear appropriate protective equipment and clothing during clean-up. Do not touch damaged containers or spilled material unless wearing appropriate protective clothing. Avoid inhalation of vapors or mists. Ensure adequate ventilation. Local authorities should be advised if significant spillages cannot be contained. For personal protection, see section 8 of the SDS. Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Cover with plastic sheet to prevent spreading. Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water. Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination. Environmental precautions 7. Handling and storage Precautions for safe handling Conditions for safe storage, including any incompatibilities Never return spills to original containers for re-use. For waste disposal, see section 13 of the SDS. Avoid discharge into drains, water courses or onto the ground. Avoid breathing mist or vapor. Avoid contact with skin. Avoid contact with eyes. Avoid contact with clothing. Provide adequate ventilation. Wear appropriate personal protective equipment. Observe good industrial hygiene practices. Store in original tightly closed container. Store away from incompatible materials (see Section 10 of the SDS). 8. Exposure controls/personal protection Occupational exposure limits Biological limit values Appropriate engineering controls exposure limits noted for ingredient(s). biological exposure limits noted for the ingredient(s). Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level. Eye wash facilities and emergency shower must be available when handling this product. Individual protection measures, such as personal protective equipment Eye/face protection Wear safety glasses with side shields (or goggles). Hand protection Wear appropriate chemical resistant gloves. 2 / 6

3 Skin protection Other Respiratory protection Thermal hazards General hygiene considerations Wear appropriate chemical resistant clothing. In case of insufficient ventilation, wear suitable respiratory equipment. Wear appropriate thermal protective clothing, when necessary. Always observe good personal hygiene measures, such as washing after handling the material and before eating, drinking, and/or smoking. Routinely wash work clothing and protective equipment to remove contaminants. Contaminated work clothing should not be allowed out of the workplace. 9. Physical and chemical properties Appearance Odor Physical state Form Color Odor threshold ph Melting point/freezing point Initial boiling point and boiling range Flash point Evaporation rate Flammability (solid, gas) Liquid. Liquid. Liquid. Amber Ammoniacal F (204 C) > F (> 93.3 C) Upper/lower flammability or explosive limits Flammability limit - lower (%) Flammability limit - upper (%) Explosive limit - lower (%) Explosive limit - upper (%) Vapor pressure Vapor density Relative density Solubility(ies) Solubility (water) Partition coefficient (n-octanol/water) Auto-ignition temperature Decomposition temperature Viscosity Other information Density Flammability class Specific gravity mm Hg 1.24 g/cm3 Combustible IIIB estimated 10. Stability and reactivity Reactivity Chemical stability Possibility of hazardous reactions Conditions to avoid Incompatible materials Hazardous decomposition products The product is stable and non-reactive under normal conditions of use, storage and transport. Material is stable under normal conditions. dangerous reaction known under conditions of normal use. Avoid temperatures exceeding the flash point. Contact with incompatible materials. Strong oxidizing agents. hazardous decomposition products are known. 3 / 6

4 11. Toxicological information Information on likely routes of exposure Ingestion Expected to be a low ingestion hazard. Inhalation Skin contact Eye contact Symptoms related to the physical, chemical and toxicological characteristics Information on toxicological effects Acute toxicity Skin corrosion/irritation Serious eye damage/eye irritation Respiratory or skin sensitization Respiratory sensitization Skin sensitization Germ cell mutagenicity Carcinogenicity Reproductive toxicity Specific target organ toxicity - single exposure Specific target organ toxicity - repeated exposure Aspiration hazard 12. Ecological information Ecotoxicity adverse effects due to inhalation are expected. Causes skin irritation. May cause an allergic skin reaction. Causes serious eye irritation. Symptoms may include stinging, tearing, redness, swelling, and blurred vision. May cause an allergic skin reaction. Skin irritation. May cause redness and pain. Dermatitis. Rash. May cause an allergic skin reaction. Causes skin irritation. Causes serious eye irritation. May cause an allergic skin reaction. data available to indicate product or any components present at greater than 0.1% are mutagenic or genotoxic. This product is not expected to cause reproductive or developmental effects. t classified. t classified. The product is not classified as environmentally hazardous. However, this does not exclude the possibility that large or frequent spills can have a harmful or damaging effect on the environment. Persistence and degradability data is available on the degradability of this product. Bioaccumulative potential Mobility in soil Other adverse effects 13. Disposal considerations Disposal instructions Local disposal regulations Hazardous waste code Waste from residues / unused products Contaminated packaging 14. Transport information DOT t regulated as dangerous goods. IATA t regulated as dangerous goods. IMDG t regulated as dangerous goods. Transport in bulk according to Annex II of MARPOL 73/78 and the IBC Code data available. data available. other adverse environmental effects (e.g. ozone depletion, photochemical ozone creation potential, endocrine disruption, global warming potential) are expected from this component. Collect and reclaim or dispose in sealed containers at licensed waste disposal site. Dispose of contents/container in accordance with local/regional/national/international regulations. Dispose in accordance with all applicable regulations. The waste code should be assigned in discussion between the user, the producer and the waste disposal company. Dispose of in accordance with local regulations. Empty containers or liners may retain some product residues. This material and its container must be disposed of in a safe manner (see: Disposal instructions). Empty containers should be taken to an approved waste handling site for recycling or disposal. Since emptied containers may retain product residue, follow label warnings even after container is emptied. 4 / 6

5 15. Regulatory information US federal regulations This product is a "Hazardous Chemical" as defined by the OSHA Hazard Communication Standard, 29 CFR TSCA Section 12(b) Export tification (40 CFR 707, Subpt. D) CERCLA Hazardous Substance List (40 CFR 302.4) t listed. US. OSHA Specifically Regulated Substances (29 CFR ) t listed. SARA 304 Emergency release notification Superfund Amendments and Reauthorization Act of 1986 (SARA) Hazard categories Immediate Hazard - Delayed Hazard - Fire Hazard - Pressure Hazard - Reactivity Hazard - SARA 302 Extremely hazardous substance SARA 311/312 Hazardous chemical SARA 313 (TRI reporting) Other federal regulations Clean Air Act (CAA) Section 112 Hazardous Air Pollutants (HAPs) List Clean Air Act (CAA) Section 112(r) Accidental Release Prevention (40 CFR ) Safe Drinking Water Act (SDWA) US state regulations US. Massachusetts RTK - Substance List US. New Jersey Worker and Community Right-to-Know Act US. Pennsylvania RTK - Hazardous Substances US. Rhode Island RTK US. California Proposition 65 California Safe Drinking Water and Toxic Enforcement Act of 1986 (Proposition 65): This material is not known to contain any chemicals currently listed as carcinogens or reproductive toxins. International Inventories Country(s) or region Inventory name On inventory (yes/no)* Australia Australian Inventory of Chemical Substances (AICS) Canada Canada China Europe Europe Japan Korea New Zealand Philippines Domestic Substances List (DSL) n-domestic Substances List (NDSL) Inventory of Existing Chemical Substances in China (IECSC) European Inventory of Existing Commercial Chemical Substances (EINECS) European List of tified Chemical Substances (ELINCS) Inventory of Existing and New Chemical Substances (ENCS) Existing Chemicals List (ECL) New Zealand Inventory Philippine Inventory of Chemicals and Chemical Substances (PICCS) 5 / 6

6 Country(s) or region Inventory name On inventory (yes/no)* United States & Puerto Rico Toxic Substances Control Act (TSCA) Inventory *A "" indicates that all components of this product comply with the inventory requirements administered by the governing country(s) A "" indicates that one or more components of the product are not listed or exempt from listing on the inventory administered by the governing country(s). 16. Other information, including date of preparation or last revision Issue date Version # 01 HMIS ratings Health: 2 Flammability: 1 Physical hazard: 0 NFPA ratings Health: 2 Flammability: 1 Instability: 0 Disclaimer The information in the sheet was written based on the best knowledge and experience currently available. 6 / 6