Common Name Synonym Catalog number Material Safety Data Sheet 1. Chemical Product and Company Identification Area of Application Plate Finisher 85S / US/C Plate Finisher 85S / US/C CIN 195535; PCD 6284; E-14.2 886518; 1511278; 16441; 131889 Industrial applications. Graphic Arts Imaging. MSDS# 311 Version 2.7 Validation Date 25-2-9 Responsible Name Kodak Polychrome Graphics Supplier Emergency telephone number Kodak Polychrome Graphics 41 Merrit 7 Norwalk, CT 6851 USA Tel. (23) 845-7 In Case of Emergency (medical/roadside) (24hrs) KPG# 561 CALL 1-8-451-8346 For other EHS Information Kodak Polychrome Graphics, Environmental, Health, & Safety Department; 11465 Johns Creek Parkway, #26, Duluth, GA 397; USA Phone 1-877-574-7274, Additional phone (77) 232-2133 E-mail PEP@kpgraphics.com, Fax (77) 232-215 2. Composition, Information on Ingredients Name CAS # % by Weight Exposure Limits 1) Water 7732-18-5 85-9 2) Dextrin 94-53-9 5-1 3) Amino-tris(methylenephosphonic acid) 6419-19-8 <1 4) Boric acid 143-35-3 <1 5) Isothiazolin derivatives Not applicable. <1 3. Hazards Identification Physical State and Appearance Emergency Overview Routes of Entry Potential Acute Health Effects Eyes May cause transient irritation. Skin Inhalation Ingestion Potential Chronic Health Effects Medical Conditions Aggravated by Overexposure Liquid. See Toxicological Information (section 11) WARNING! MAY CAUSE ALLERGIC SKIN REACTION. Avoid prolonged or repeated breathing of vapor. Avoid prolonged contact with eyes, skin, and clothing. Use with adequate ventilation. Wash thoroughly after handling. Absorbed through skin. Eye contact. Inhalation. Ingestion. Irritation of the product in case of skin contact Slightly hazardous in case of skin contact (sensitizer). Low hazard for recommended handling Low hazard for recommended handling CARCINOGENIC EFFECTS MUTAGENIC EFFECTS TERATOGENIC EFFECTS Repeated or prolonged exposure is not known to aggravate medical condition.
Plate Finisher 85S / US/C Page 2/5 4. First Aid Measures Eye Contact Skin Contact Inhalation Ingestion Check for and remove any contact lenses. In case of contact, immediately flush eyes with plenty of water for at least 15 minutes. Get medical attention if symptoms occur. In case of contact, immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Wash contaminated clothing before reusing. Get medical attention if symptoms occur. Allow the victim to rest in a well-ventilated area. Get medical attention if symptoms occur. Do not induce vomiting. Have conscious person drink several glasses of water or milk. Seek medical attention. 5. Fire Fighting Measures Flammability of the Product thermal (de)composition products Fire Hazards in Presence of Various Substances Explosion Hazards in Presence of Various Substances Fire Fighting Media and Instructions Protective Clothing (Fire) Non combustible. These products are carbon oxides (CO, CO2). Use DRY chemicals, CO2, water spray or foam. Be sure to use an approved/certified respirator or equivalent. 6. Accidental Release Measures Small Spill and Leak Large Spill and Leak 7. Handling and Storage Dilute with water and mop up, or absorb with an inert dry material and place in an appropriate waste disposal container. Finish cleaning by spreading water on the contaminated surface and dispose of according to local and regional authority requirements. Absorb with an inert material and put the spilled material in an appropriate waste disposal. Neutralize the residue with a dilute solution of sodium carbonate. Finish cleaning by spreading water on the contaminated surface and dispose of according to local and regional authority requirements. Handling Storage Do not ingest. Avoid prolonged or repeated breathing of vapor. Avoid prolonged contact with eyes, skin, and clothing. Use with adequate ventilation. Wash thoroughly after handling. Store at room temperature 25 C (77 F) or lower. Prevent from freezing 8. Exposure Controls, Engineering Controls Eyes Body Respiratory Hands Feet Ventilation is normally required when handling or using this product (typically 1 air changes per hour). Ensure that eyewash stations and safety showers are close to the work-station location. Safety glasses. Synthetic apron. Not applicable. Impervious gloves. Not applicable.
Plate Finisher 85S / US/C Page 3/5 Protective Clothing (Pictograms) in Case of a Large Spill Splash goggles. Lab coat. Impervious gloves. Ventilation is normally required when handling or using this product (typically 1 air changes per hour). Product Name Exposure Limits 1) Water 2) Dextrin 3) Amino-tris(methylenephosphonic acid) 4) Boric acid 5) Isothiazolin derivatives Consult local authorities for acceptable exposure limits. 9. Physical and Chemical Properties Physical State and Appearance Liquid. Odor Color Odorless. Orange. ph 2.1 [Acidic.] Boiling/Condensation Point >1 C (212 F) Melting/Freezing Point Specific Gravity < C (32 F) 1.4 (Water = 1) Vapor Pressure 2.4 kpa (@ 2 C) Vapor Density.6 (Air = 1) VOC Calculated 121.97 g/l (1.18 lbs/gal.). Dispersion Properties See solubility in water. Solubility Easily soluble in cold water. 1. Stability and Stability and Conditions of Instability Incompatibility with Various Substances Decomposition Products Polymerization The product is stable. Incompatible with some alkalis. Incompatible with strong oxidizing agents. These products are carbon oxides (CO, CO2). Will not occur. 11. Toxicological Information Toxicity to Animals Water ORAL (LD5) Acute >9 mg/kg [Rat]. Dextrin LD5 LC5 Amino-tris(methylenephosphonic acid) ORAL (LD5) Acute 291 mg/kg [Rat]. DERMAL (LD5) Acute >631 mg/kg [Rabbit]. Boric acid ORAL (LD5) Acute >3 mg/kg [Rat]. DERMAL (LD5) Acute >2 mg/kg [Rabbit].
Plate Finisher 85S / US/C Page 4/5 Chronic Effects on Humans Other Toxic Effects on Humans DUST (LC5) Acute >2 mg/l 4 hour(s) [Rat]. Isothiazolin derivatives LD5 LC5 12. Ecological Information Slightly hazardous in case of skin contact (sensitizer). Organics Readily Degradable (7%) Ecotoxicity Toxicity of the Products of Biodegradation Yes. (14 day(s)) The product itself and its products of degradation are not toxic. 13. Disposal Considerations Waste Information Waste must be disposed of in accordance with federal, state and local environmental control regulations. Consult your local or regional authorities. 14. Transport Information DOT Not a DOT controlled material (United States). TDG ADR/RID IMO/IMDG ICAO/IATA Not controlled under TDG (Canada). Not controlled under ADR of the EEC. Not controlled under IMDG. Not controlled under IATA. 15. Regulatory Information HCS CLASS Sensitizing substance. U.S. Federal Regulations SARA 313 Reporting Requirements International Regulations WHMIS (Canada) TSCA 8(b) inventory All the ingredients are on the TSCA list. SARA 32 extremely hazardous substances No products were found. SARA 34 emergency planning and notification No products were found. SARA 311/312 MSDS distribution - chemical inventory - hazard identification No products were found. No products were found. Clean Water Act (CWA) 37 No products were found. Clean Water Act (CWA) 311 No products were found. Clean air act (CAA) 112(r) accidental release prevention No products were found. Class D-2B Material causing other toxic effects (TOXIC). This product has been classified in accordance with hazard criteria of the Controlled Products Regulations and the MSDS contains all the information required by the Controlled Products Regulations. CEPA DSL All the ingredients are on the DSL list.
Plate Finisher 85S / US/C Page 5/5 DSCL (EEC) R43- May cause sensitization by skin contact. State Regulations No products were found. California prop. 65 No products were found. 16. Other Information Material Information System (U.S.A.) Health Fire Hazard * 2 National Fire Protection Association C (U.S.A.) Health 1 Fire Hazard Specific Hazard References Other Special Considerations Validated by Kodak Polychrome Graphics on 25-2-9. In Case of Emergency CALL 1-8-451-8346 Verified by Kodak Polychrome Graphics. Printed 25-2-9. Notice to Reader To the best of our knowledge, the information contained herein is accurate. However, neither the above named supplier nor any of its subsidiaries assumes any liability whatsoever for the accuracy or completeness of the information contained herein. Final determination of suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein, we cannot guarantee that these are the only hazards that exist. FOR INDUSTRIAL USE ONLY