Safety Data Sheet according to (EC) No 1907/2006 STYCAST 2850 FT BLUE(BE) 20KG P Page 1 of 9 sds no. : 373795 Revision: 17.05.2011 printing date: 22.06.2011 SECTION 1: Identification of the substance/mixture and of the company/undertaking Product identifier: STYCAST 2850 FT BLUE(BE) 20KG P Relevant identified uses of the substance or mixture and uses advised against: Intended use: Epoxy adhesive Details of the supplier of the safety data sheet: Henkel Limited 2 Bishop Square Business Park AL109EY Herfordshire Hatfield Great Britain Phone: +44 1606 593933 Fax-no.: +44 1606 863762 ua-productsafety.uk@uk.henkel.com Emergency telephone number: 24 Hours Emergency Tel: +44 (0)1442 278497 Classification of the substance or mixture: SECTION 2: Hazards identification Classification (DPD): carcinogenic, category 3 R40 Limited evidence of a carcinogenic effect. Mutagen category 3. R68 Possible risk of irreversible effects. Sensitizing R43 May cause sensitisation by skin contact. Xi - Irritant R36/38 Irritating to eyes and skin. Dangerous for the environment R52/53 Harmful to aquatic organisms, may cause long-term adverse effects in the aquatic environment.
STYCAST 2850 FT BLUE(BE) 20KG P Page 2 of 9 Label elements (DPD): Xn - Harmful Risk phrases: R36/38 Irritating to eyes and skin. R40 Limited evidence of a carcinogenic effect. R43 May cause sensitisation by skin contact. R52/53 Harmful to aquatic organisms, may cause long-term adverse effects in the aquatic environment. R68 Possible risk of irreversible effects. Safety phrases: S24 Avoid contact with skin. S26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. S36/37 Wear suitable protective clothing and gloves. S51 Use only in well-ventilated areas. S61 Avoid release to the environment. Refer to special instructions/safety data sheets. Additional labeling: Contains epoxy constituents. See information supplied by the manufacturer. Contains: Bisphenol-A epichlorhydrin resin MW <= 700, RP Bisphenol F-epichlorohydrin resin, MW<=700, Other hazards: None if used properly. General chemical description: Adhesive Base substances of preparation: Epoxy resin SECTION 3: Composition/information on ingredients
STYCAST 2850 FT BLUE(BE) 20KG P Page 3 of 9 Declaration of the ingredients according to CLP (EC) No 1272/2008: Bisphenol-A epichlorhydrin resin MW <= 700 25068-38-6 EC Number REACH-Reg No. content Classification 500-033-5 >= 20- < 25 % Chronic hazards to the aquatic environment 2 H411 Serious eye irritation 2 H319 Skin irritation 2 H315 Skin sensitizer 1 H317 219-376-4 >= 1- < 5 % Acute toxicity 4; Inhalation H332 Germ cell mutagenicity 2 H341 Acute toxicity 4; Oral H302 Carcinogenicity 2 H351 Specific target organ toxicity - single exposure 3 H335 Flammable liquids 3 H226 Skin sensitizer 1 H317 Chronic hazards to the aquatic environment 3 H412 Only dangerous ingredients for which a CLP classification is already available are displayed in this table. For full text of the H - statements and other abbreviations see section 16 "Other information". Substances without classification may have community workplace exposure limits available. Declaration of ingredients according to DPD (EC) No 1999/45: Bisphenol-A epichlorhydrin resin MW <= 700 25068-38-6 RP Bisphenol F-epichlorohydrin resin, MW<=700 28064-14-4 EC Number REACH-Reg No. content Classification 500-033-5 >= 20 - < 25 % N - Dangerous for the environment; R51, R53 R43 Xi - Irritant; R36/38 >= 1 - < 2,5 % Xi - Irritant; R36/38, R43 N - Dangerous for the environment; R51/53 219-376-4 >= 1 - < 5 % Mutagen category 3.; R68 R10 Xi - Irritant; R37 R43 R52, R53 carcinogenic, category 3; R40 Xn - Harmful; R20/22 For full text of the R-Phrases indicated by codes see section 16 'Other Information'. Substances without classification may have community workplace exposure limits available. Description of first aid measures: SECTION 4: First aid measures Inhalation: Should not be a problem as product is of low volatility. However, if feeling unwell remove patient to fresh air. Skin contact: Rinse with running water and soap. Obtain medical attention if irritation persists. Eye contact: Rinse immediately with plenty of running water (for 10 minutes), seek medical attention from a specialist.
STYCAST 2850 FT BLUE(BE) 20KG P Page 4 of 9 Ingestion: Rinse mouth, drink 1-2 glasses of water, do not induce vomiting, consult a doctor. Most important symptoms and effects, both acute and delayed: EYE: Irritation, conjunctivitis. SKIN: Redness, inflammation. SKIN: Rash, Urticaria. Indication of any immediate medical attention and special treatment needed: See section: Description of first aid measures Extinguishing media: Suitable extinguishing media: water, carbon dioxide, foam, powder SECTION 5: Firefighting measures Extinguishing media which must not be used for safety reasons: High pressure waterjet Special hazards arising from the substance or mixture: In the event of a fire, carbon monoxide (CO) and carbon dioxide (CO2) can be released. In case of fire, keep containers cool with water spray. Advice for firefighters: Wear self-contained breathing apparatus and full protective clothing, such as turn-out gear. SECTION 6: Accidental release measures Personal precautions, protective equipment and emergency procedures: Avoid contact with skin and eyes. Wear protective equipment. Environmental precautions: Do not empty into drains / surface water / ground water. Methods and material for containment and cleaning up: For small spills wipe up with paper towel and place in container for disposal. For large spills absorb onto inert absorbent material and place in sealed container for disposal. Reference to other sections: See advice in chapter 8 Precautions for safe handling: Avoid skin and eye contact. See advice in chapter 8 Hygiene measures: Good industrial hygiene practices should be observed. Wash hands before work breaks and after finishing work. Do not eat, drink or smoke while working. SECTION 7: Handling and storage Conditions for safe storage, including any incompatibilities: Ensure good ventilation/extraction. Keep container tightly sealed. Store at room temperature.
STYCAST 2850 FT BLUE(BE) 20KG P Page 5 of 9 Specific end use(s): Epoxy adhesive SECTION 8: Exposure controls/personal protection Control parameters: Valid for Great Britain Exposure controls: Engineering controls: Ensure good ventilation/extraction. Respiratory protection: Ensure adequate ventilation. An approved mask or respirator fitted with an organic vapour cartridge should be worn if the product is used in a poorly ventilated area Filter type: A Hand protection: Chemical-resistant protective gloves (EN 374). Suitable materials for short-term contact or splashes (recommended: at least protection index 2, corresponding to > 30 minutes permeation time as per EN 374): nitrile rubber (NBR; >= 0.4 mm thickness) Suitable materials for longer, direct contact (recommended: protection index 6, corresponding to > 480 minutes permeation time as per EN 374): nitrile rubber (NBR; >= 0.4 mm thickness) This information is based on literature references and on information provided by glove manufacturers, or is derived by analogy with similar substances. Please note that in practice the working life of chemical-resistant protective gloves may be considerably shorter than the permeation time determined in accordance with EN 374 as a result of the many influencing factors (e.g. temperature). If signs of wear and tear are noticed then the gloves should be replaced. Eye protection: Safety glasses with sideshields or chemical safety goggles should be worn if there is a risk of splashing. Skin protection: Wear suitable protective clothing. SECTION 9: Physical and chemical properties Information on basic physical and chemical properties: Appearance liquid blue Odor Mild ph Initial boiling point Flash point Decomposition temperature Vapour pressure Density () Bulk density Viscosity Viscosity (kinematic) Explosive properties Solubility (qualitative) Solidification temperature Melting point Flammability Auto-ignition temperature > 93 C (> 199.4 F) 2,4 g/cm3
STYCAST 2850 FT BLUE(BE) 20KG P Page 6 of 9 Explosive limits Partition coefficient: n-octanol/water Evaporation rate Vapor density Oxidising properties Other information: SECTION 10: Stability and reactivity Reactivity: Reacts with alcohols and amines. Reacts with oxidants, acids and lyes Reaction with some curing agents may produce an exothermic reaction which in large masses could cause runaway polymerization. Chemical stability: Stable under recommended storage conditions. Possibility of hazardous reactions: See section reactivity Conditions to avoid: No decomposition if stored and applied as directed. Incompatible materials: None if used properly. Hazardous decomposition products: Hydrocarbons carbon oxides. nitrogen oxides Rapid polymerisation may generate excessive heat and pressure. SECTION 11: Toxicological information General toxicological information: The preparation is classified based on the conventional method outlined in Article 6(1)(a) of Directive 1999/45/EC. Relevant available health/ecological information for the substances listed under Section 3 is provided in the following. Possible risk of irreversible effects. Oral toxicity: May cause irritation to the digestive tract. Inhalative toxicity: May cause irritation to respiratory system. Skin irritation: It is irritating and sensitising to the skin Eye irritation: Irritating to eyes. Carcinogenicity: Limited evidence of a carcinogenic effect
STYCAST 2850 FT BLUE(BE) 20KG P Page 7 of 9 Germ cell mutagenicity: Bisphenol-A epichlorhydrin resin MW <= 700 25068-38-6 Result Type of study / Route of administration positive bacterial reverse mutation assay (e.g Ames test) Metabolic activation / Exposure time with and without Species Method SECTION 12: Ecological information General ecological information: The preparation is classified based on the conventional method outlined in Article 6(1)(a) of Directive 1999/45/EC. Relevant available health/ecological information for the substances listed under Section 3 is provided in the following. Ecotoxicity: May cause long-term adverse effects in the aquatic environment. Harmful to aquatic organisms. Mobility: Cured adhesives are immobile. Persistence and Biodegradability: The product is not biodegradable. Toxicity: Value type Value Acute Toxicity Study Exposure time Species LC50 65 mg/l Fish 96 h Salmo gairdneri (new name: Oncorhynchus mykiss) EC50 35 mg/l Algae 96 h Selenastrum capricornutum (new name: Pseudokirchnerella subcapitata) Method OECD Guideline 203 (Fish, Acute Toxicity Test) OECD Guideline 201 (Alga, Growth Inhibition Test) Persistence and degradability: Result Route of application Degradability Method 25 % OECD Guideline 301 D (Ready Biodegradability: Closed Bottle Test) Bioaccumulative potential / Mobility in soil: LogKow Bioconcentration factor (BCF) 0,63 Exposure time Species Temperature Method SECTION 13: Disposal considerations Waste treatment methods:
STYCAST 2850 FT BLUE(BE) 20KG P Page 8 of 9 Product disposal: Do not empty into drains / surface water / ground water. Dispose of in accordance with local and national regulations. Disposal of uncleaned packages: After use, tubes, cartons and bottles containing residual product should be disposed of as chemically contaminated waste in an authorised legal land fill site or incinerated. Waste code 08 04 09 waste adhesives and sealants containing organic solvents and other dangerous substances The valid EWC waste code numbers are source-related. The manufacturer is therefore unable to specify EWC waste codes for the articles or products used in the various sectors. The EWC codes listed are intended as a recommendation for users. We will be happy to advise you. SECTION 14: Transport information General information: Not hazardous according to RID, ADR, ADNR, IMDG, IATA-DGR. SECTION 15: Regulatory information Safety, health and environmental regulations/legislation specific for the substance or mixture: VOC content < 3,00 % (1999/13/EC)
STYCAST 2850 FT BLUE(BE) 20KG P Page 9 of 9 SECTION 16: Other information The labelling of the product is indicated in Section 2. The full text of all abbreviations indicated by codes in this safety data sheet are as follows: R10 Flammable. R20/22 Harmful by inhalation and if swallowed. R36/38 Irritating to eyes and skin. R37 Irritating to respiratory system. R40 Limited evidence of a carcinogenic effect. R43 May cause sensitisation by skin contact. R51 Toxic to aquatic organisms. R51/53 Toxic to aquatic organisms, may cause long-term adverse effects in the aquatic environment. R52 Harmful to aquatic organisms. R53 May cause long-term adverse effects in the aquatic environment. R68 Possible risk of irreversible effects. H226 Flammable liquid and vapour. H302 Harmful if swallowed. H315 Causes skin irritation. H317 May cause an allergic skin reaction. H319 Causes serious eye irritation. H332 Harmful if inhaled. H335 May cause respiratory irritation. H341 Suspected of causing genetic defects. H351 Suspected of causing cancer. H411 Toxic to aquatic life with long lasting effects. H412 Harmful to aquatic life with long lasting effects. Further information: This information is based on our current level of knowledge and relates to the product in the state in which it is delivered. It is intended to describe our products from the point of view of safety requirements and is not intended to guarantee any particular properties.