S.C. Moldoveanu, A.G. Hudson, A. Harrison. R.J. Reynolds Tobacco Co.

Transcription

1 The Determination of Diacetyl and Acetylpropionyl in Aerosols from Electronic Smoking Devices using Gas Chromatography Triple Quad Mass Spectrometry S.C. Moldoveanu, A.G. Hudson, A. Harrison R.J. Reynolds Tobacco Co.

2 Background 2,3-Butanedione (diacetyl) is used as a flavoring agent in food and it is a component of certain fragrances. Also the compound occurs naturally in certain alcoholic and non-alcoholic beverages and in several types of tobacco. Concerns have been raised about exposure to diacetyl, and it has been indicated that the compound may contribute or may even cause severe respiratory disorders in the workplace. Occupational Safety and Health Administration (OSHA) issued a guidance regarding the use of diacetyl as a food flavoring. National Institute for Occupational Safety and Health (NIOSH) also issued a number of reports regarding the exposure to diacetyl and 2,3-pentanedione (acetylpropionyl) in the working place. Analysis of diacetyl and acetylpropionyl in mainstream cigarette smoke (burndown products) and in aerosol (both the particles and the suspending gas) from electronic smoking devices (e-cigarettes) is of considerable interest.

3 Background (cont.) Measurements for diacetyl were performed on various matrices such as wine, beer, various types of food, urine, and air. The analysis of diacetyl in e-liquids and tobacco products has been previously reported and the procedures can be based on gas chromatography followed by mass spectrometry, or on HPLC. A CORESTA method for the analysis of aldehydes and ketones in smoke from cigarettes [1] has been modified to include the measurement of diacetyl and acetylpropionyl [2] at μg level. The evaluation of diacetyl and acetylpropionyl in e-vapor products has been previously presented at TSRC [3,4]. 1. CORESTA Recommended Method No March Cooperation Centre for Scientific Research Relative to Tobacco (CORESTA). 2. Pierce, J. S., A. Abelmann, L. J. Spicer, R. E. Adams, B. L. Finley: Crit. Rev. Toxicol, 44 (2014) Huang. C. B., K. Wagner, J. W. Flora, 69 th Tobacco Science Research Conference, Naples, Fl, Sept , 2015, Paper Fraley N., 70 th Tobacco Science Research Conference, Palm Beach Gardens, Fl, Sept , 2016, Poster 18.

4 Analytical method summary The aerosols from e-cigarettes were collected using a Cerulean SM 450 Linear Smoke Machine (Cerulean SM 450,Milton Keynes, UK) using a square wave profile. The collection from the e-cigarettes was performed on a Cambridge pad and one impinger containing 10 ml acetone. The e-liquids were obtained either directly from bottles or removed from cartridges by centrifugation. The analysis used a gas chromatographic separation on a Carbowax type column with the measurement of the analytes on a triplequad mass spectrometer (GC-MS/MS) working in positive MRM mode. The GC-MS/MS was 7890B-7000C from Agilent (Agilent Technologies Inc., Wilmington, DE, USA). The separation was performed on an Agilent J&W DB-WaxEtr chromatographic column, 30 m x 0.25 mm i.d. with 0.25 μm film.

5 Analytical method (details on sample collection) The smoking regimen for aerosol collection was 55 ml puff volume, 3 second puff duration, and 30 second puff interval. Depending on the electronic smoking device, 50 puffs or 100 puffs were collected at specific puff intervals such as 1-50, , etc. The impingers were weighed before and after sample collection to determine the remaining volume of acetone (some acetone evaporates during smoking). After the samples were collected, the particulate phase pads were placed in the impinger containing the corresponding vapor phase and extracted (to create combined whole aerosol samples). An aliquot of 1mL sample was taken and d 7 -quinoline is added. The collection of smoke from 3R4F Kentucky reference cigarette was performed under ISO or HCI protocols, using a Cambridge pad followed by two impingers each with 50 ml acetone and glass beads.

6 Publication of the method The present method has been published: S. C. Moldoveanu, A. G. Hudson, W. A. Scott, A. Harrison, The Determination of Diacetyl and Acetylpropionyl in Aerosols from Electronic Smoking Devices using Gas Chromatography Triple Quad Mass Spectrometry, Beitraege Tabak. Intern., 27(7) (2017)

7 Analytical method (details on GC separation) Parameter Description Parameter Description Initial oven temp. 35 C Inlet initial temp. 120 C Initial time 7.0 min Initial time 7 min Oven ramp rate 2.5 C/min Heating rate 600 o C/min Oven final first ramp 50 C Final inlet temp. 290 o C Final time first ramp 0 min Injection volume 3.0 ml Oven ramp rate 30 C/mm Carrier gas Helium Oven final second ramp 260 o C Flow mode Constant flow Final time 5.0 min Flow rate 1.1 ml/min Total run time 25 min Nominal initial pressure 12.2 psi Inlet type Multi Mode Average flow velocity cm/sec Inlet mode Pulse splitless Total flow 19.1 ml/min Pulse pressure 20 psi Holdup time 1.88 min Purge flow time 0.75 min Outlet pressure Vacuum Purge flow 15 ml/min Transfer line heater 280 C

8 Analytical method (details on MS/MS parameters) Parameter Description Ion source EI Acquisition mode MRM (positive) Source temperature 230 o C Collision cell He 2.25 ml/min N 2 collision gas 1.5 ml/min Gain factor 10 Diacetyl transition CE energy for diacetyl 2 V Acetylpropionyl transition CE energy for acetylpropionyl 1 V d 7 -Quinoline transition CE energy for d 7 -quinoline l 5 V MS1 resolution Unit MS2 resolution Unit Dwell time for each compound 150 ms

9 Typical chromatogram for a sample containing about 50 ng/ml of the analytes with I.S. at 50 ng/ml d 7 -quinoline

10 Analytical method (various details) Calibration standards in ng/ml. Standard Compound Level 7 Level 6 Level 5 Level 4 Level 3 Level 2 Level 1 Diacetyl Acetylpropionyl Coefficients for the calibration curves Y = a X 2 + b X + c used in quantitation, Y = ng/ml, X = (analyte area)/(i.s. area) Compound a b c R 2 Diacetyl Acetylpropionyl Internal standard (d 7 -quinolone) concentration in the analyzed samples was 50 ng/ml

11 Method validation Limit of detection (LOD) and limit of quantitation (LOQ) in ng/ml. Compound LOD (ng/ml) LOQ (ng/ml) Diacetyl Acetylpropionyl Limit of detection (LOD) and limit of quantitation (LOQ) in ng/puff for 50 puffs per pad extracted with 10 ml acetone. Compound LOD (ng/puff) LOQ (ng/puff) Diacetyl Acetylpropionyl Limit of detection (LOD) and limit of quantitation (LOQ) in ng/g e- liquid for 0.5 g e-liquid in 10 ml acetone. Compound LOD (ng/g) LOQ (ng/g) Diacetyl Acetylpropionyl

12 Method validation Relative standard deviation (RSD%) for standard Level 1 (1.05 ng/ml diacetyl and 1.23 ng/ml acetylpropionyl), and standard Level 3 (21.0 ng/ml diacetyl and 24.6 ng/ml acetylpropionyl) Compound Level 1 Level 3 Diacetyl 3.91% (n = 5) 4.89% (n = 10) Acetylpropionyl 1.48% (n = 5) 3.36% (n = 10)

13 Method validation (cont.) Results for the recovery study in ng/ml Sample Added diacetyl Diacetyl ng/ml Recovery % Added acetylpropionyl Acetylpropionyl ng/ml Recovery% E-Cig. X puffs RSD% E-Cig. X puffs RSD% E-Cig. X puffs RSD% E-Cig. X puffs RSD% E-Cig. X puffs RSD% E-Cig. X puffs RSD% Results in ng/puff for diacetyl and acetylpropionyl from two different smoking devices and two impinger collection. Electronic device/flavor Impinger 1 + Pad Diacetyl Impinger 2 Acetylpropionyl Impinger 1 + Pad Impinger 2 Device 1 ng/puff RSD% Device 2 ng/puff RSD%

14 Method validation (cont.) Results in μg/cigarette for diacetyl in 3R4F cigarettes. Smoking protocol Pad Impinger 1 Impinger 2 Total ISO Average μg/cig RSD% HCI Average μg/cig RSD% Results in μg/cigarette for acetylpropionyl in 3R4F cigarettes. Smoking protocol Pad Impinger 1 Impinger 2 Total ISO Average μg/cig RSD% HCI Average μg/cig RSD% Literature reference [1] indicated an average of μg/cig diacetyl and 15.4 μg/cig acetylpropionyl for ISO smoking. 1. Pierce, J. S., A. Abelmann, L. J. Spicer, R. E. Adams, B. L. Finley, Crit. Rev. Toxicol, 44 (2014) (pag. 422)

15 Results for aerosols from various smoking devices expressed in ng/puff Sample description Diacetyl Acetylpropionyl Brand Puff range ng/puff RSD% ng/puff RSD% E-cig. A E-cig. A E-cig. A E-cig. A E-cig. B E-cig. B E-cig. B E-cig. B E-cig. C E-cig. C E-cig. C E-cig. C E-cig. D E-cig. D E-cig. D E-cig. D

16 Results for aerosols from various smoking devices expressed in ng/puff (cont.) Sample description Diacetyl Acetylpropionyl Brand Puff range ng/puff RSD% ng/puff RSD% E-cig. E E-cig. E E-cig. F E-cig. F E-cig. G E-cig. G E-cig. H E-cig. H E-cig. I E-cig. J E-cig. K E-cig. K E-cig. L E-cig. L

17 Results for diacetyl in the aerosols from various smoking devices expressed in ng/puff

18 Results for acetylpropionyl in the aerosols from various smoking devices expressed in ng/puff

19 Results for various e-liquids expressed in ng/g Sample description Diacetyl Acetylpropionyl ng/g RSD% ng/g RSD% 1 E-liquid E-liquid E-liquid E-liquid E-liquid E-liquid E-liquid E-liquid E-liquid E-liquid E-liquid E-liquid E-liquid E-liquid E-liquid E-liquid E-liquid E-liquid

20 Results for various e-liquids expressed in ng/g (cont.) Sample description Diacetyl Acetylpropionyl ng/g RSD% ng/g RSD% 19 E-liquid E-liquid E-liquid E-liquid E-liquid E-liquid E-liquid E-liquid E-liquid * E-liquid E-liquid E-liquid E-liquid E-liquid E-liquid * E-liquid * E-liquid * * 3 36 E-liquid * E-liquid * *Note: These values were outside the calibration range and were calculated based on a linear dependence Y (ng/ml) = X (for diacetyl) and Y = X (for acetylpropionyl).

21 Results for aerosols from various smoking devices expressed in ng/puff

22 Results for acetylpropionyl in various e-liquids expressed in ng/g

23 Conclusions A new method for the quantitation of diacetyl and acetylpropionyl in the aerosols of electronic smoking devices (ecigarettes) has been developed. The method also has been applied for the measurements of these two analytes in the liquids used in e-cigarettes (e-liquids). The method uses a GC-MS/MS instrument with separation on a Carbowax type column and detection in MRM positive mode. The method has been validated. The limit of quantitation (LOQ) for the method was determined to be 0.41 ng/ml for diacetyl and 0.21 ng/ml for acetylpropionyl as measured for standards. The accuracy of the method has been verified on a 3R4F Kentucky reference cigarette. The results for different e-cigarette brands and e-liquids indicated a wide range of levels of the two analytes.