NOE LOBBY RANGE NOE LOBBY C - 1/2 hrs CMV/Collective extraction units Flow rate 400 to m 3 /h COLLECTIVE VENTILATION

Transcription

1 COLLECTIVE VENTILATION NOE LOBBY RANGE NOE LOBBY 4 4 C - 1/2 hrs CMV/Collective extraction units Flow rate 4 to 114 m 3 /h 4

2 4 COLLECTIVE VENTILATION Ventilation unit PULLEY/BELT TRANSMISSION 4 to 114 m 3 /h C4 EXTRACTION UNIT DESCRIPTION CTICM C4-4 C - 1/2 h approved Report no. 9-E-4 CSTB technical notification for Hygro A, Hygro B and Hygro Gas usage CMV POWER APPLICATION selection software APPLICATION Intended mainly for air extraction in houses and public assembly buildings requiring average and high flow rates at low consumption constant pressure. C4, 4 C 1/2 h certified. 23 V SINGLE PHASE 5 Hz and 6 Hz power supply. Econological solution : maintaining the installation at constant pressure over the whole of the flow rate range of the unit provides low energy consumption since the fan rotation speed will be adapted instantaneously to the requirements of the installation. The energy consumption gains thus obtained are of the order of 3 to 6%. Operating the installation at constant pressure at reduced flow rate also lowers the sound levels radiated by the system. GAMME Comprising 1 models, it covers flow rates from 4 to 114 m3 /h in a number of configurations. INSTALLATION Can be installed internally or externally. Easy access to all internal parts. May be fully dismantled CONSTRUCTION Housing: galvanized steel sheet. Amply dimensioned, it offers powerful air handling and acoustic performance characteristics. Internal access via two removable panels. Bird protection grid on discharge. Two circular branch connections with double lip seals. LOBBY unit IP fitted with a speed controller and a pressure sensor with signal integrator fitted and wired as standard. Setpoint pressure adjustable via the console built in to the LOBBY unit. Factory set to 18 Pa. Local padlockable switch on front panel. External pressure tap to check air flow. The incorporates an air flow defect relay. This is programmed using the following information: Defect: contact signal if pressure less than 5 Pa. Mistral 3 S: time delay of 3 secs on the defect contact in order not to trigger spurious alarms Indicator light: a contact is available for connecting a green indicator light showing the unit is in operation. Vibration pads incorporated under the chassis of the motorised fan unit. SILENCE version 4 C 1/2 h certified. The insulation of the unit using 25 mm M eral wool allows acoustic performance characteristics compliant with the requirements of the new regulations to be achieved. MOTOR FAN Transmission by pulley and belt, motor pulley variable when stopped. Three-phase one-speed motor, IP55 class F, 23V/1/5 Hz. Door opening sensor available for office ventilation. Centrifugal impulse turbine with double opening. Flexible connection from turbine to unit. Spare belt supplied. The units are available in two versions: H: 1 horizontal intake Ø D1 + 1 horizontal discharge Ø D2 in-line V: 1 horizontal intake Ø D1 + 1 horizontal intake Ø D2 + 1 vertical discharge LxL1 For the dimensions of the NOE LOBBY, refer to the table on page 21. ELECTRICAL CHARACTERISTICS Reference Motor power Current protection at Power supply (kw) 23 V single phase (A) (V/phase/Hz) NOE 26 LOBBY,37 3,3 23 / 1 / 5 NOE 3 LOBBY,55 4,2 23 / 1 / 5 NOE 34 LOBBY,55 4,2 23 / 1 / 5 NOE 38 LOBBY,75 5,7 23 / 1 / 5 NOE LOBBY,75 5,7 23 / 1 / 5 NOE 56 LOBBY 1,1 7,8 23 / 1 / 5 NOE 68 LOBBY 1,1 7,8 23 / 1 / 5 NOE 8 LOBBY 1,5 1,5 23 / 1 / 5 NOE 1 LOBBY 1,5 1,5 23 / 1 / 5 NOE 114 LOBBY 2,2 14,4 23 / 1 / 5 NOTA : The curves are made with a suction and discharge nozzle connected subwoofer is not connected (C configuration according to NF N ).

3 SELECTION CURVES 4 NOE 26 NOE LOBBY NOE 3 NOE LOBBY NOE 34 NOE LOBBY NOE 38 NOE LOBBY NOE NOE LOBBY

4 COLLECTIVE 4 VENTILATION SELECTION CURVES NOE 56 NOE LOBBY NOE 68 NOE LOBBY NOE 8 NOE LOBBY NOE 1 NOE LOBBY NOE 114 NOE LOBBY

5 MOUNTING OPTIONS C4 THERMOMAGNETIC CIRCUIT BREAKER ref. DMT Function: in compliance with standard NFS 15-1, provides electrical protection to the motor. CHAMFERED DUCT TERMINATION WITH MESH ref. BBG Function: rain and bird protection for the horizontal discharge (HH) from units located externally. Diameter of branch connections: 16 to 8 mm. AUTOTRANSFORMER SPEED CONTROLLER IN BOX WITH BUILT-IN SELECTOR ref. VATM Function: fan speed variation by means of 5-position manual selector. VATM: for 23V single-phase motor. FLEXIBLE MO SLEEVE ref. MTS MO Function: circular connection to ventilation system. Diameter of branch connections: 16 to 8 mm. FLAT COVER FOR VERTICAL DISCHARGE ref. CP Function: rain protection for units with vertical discharge (HV) installed outside. Diameter of branch connections: 16 to 8 mm. PRESSURE SWITCH TIME DELAY ref. MISTRAL 3S IP55 pressure switch time delay unit to cope with gusts of wind. MANUFACTURING OPTIONS C4 CONDENSATE DRAINAGE ref. ECNOE Located at the bottom of the unit, this condensate tray allows the NOE unit to be used where there are special operational constraints. MAY BE DISMANTLED In line, NOE and NOE LOBBY units can be dismantled.