SAFETY DATA SHEET. Revision Date 02-Feb-2017 Revision Number Identification. No information available

Transcription

1 SAFETY DATA SHEET Revision Number 2 Product Name Cat. : Synonyms Recommended Use 1. Identification Mueller Hinton Agar R01620, R01624, R04050, R4052, R09592 Laboratory chemicals. Uses advised against Information available Details of the supplier of the safety data sheet Company Remel Santa Fe Drive Lenexa, KS United States Telephone: Fax: Emergency Telephone Number INFOTRAC - 24 Hour Number: Outside of the United States, call 24 Hour Number: (Call Collect) 2. Hazard(s) identification Classification Classification under 2012 OSHA Hazard Communication Standard (29 CFR ) Based on available data, the classification criteria are not met Label Elements Hazard Statements Precautionary Statements Hazards not otherwise classified (HNOC) ne identified 3. Composition / information on ingredients Component CAS- Weight % Zinc chloride Trace Page 1 / 6

2 4. First-aid measures Eye Contact Skin Contact Inhalation Ingestion Most important symptoms/effects tes to Physician Unsuitable Extinguishing Media Flash Point Method - Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Wash off immediately with plenty of water for at least 15 minutes. Move to fresh air. Do not induce vomiting. Causes burns by all exposure routes. Product is a corrosive material. Use of gastric lavage or emesis is contraindicated. Possible perforation of stomach or esophagus should be investigated: Ingestion causes severe swelling, severe damage to the delicate tissue and danger of perforation Treat symptomatically 5. Fire-fighting measures Autoignition Temperature Explosion Limits Upper Lower Sensitivity to Mechanical Impact Sensitivity to Static Discharge Specific Hazards Arising from the Chemical Keep product and empty container away from heat and sources of ignition. Hazardous Combustion Products ne known Protective Equipment and Precautions for Firefighters As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH (approved or equivalent) and full protective gear. NFPA Health 1 Flammability 0 Instability 0 Physical hazards N/A Personal Precautions Environmental Precautions 6. Accidental release measures Ensure adequate ventilation. Use personal protective equipment. See Section 12 for additional ecological information. Methods for Containment and Clean Sweep up and shovel into suitable containers for disposal. Prevent product from entering Up drains. Handling Storage Exposure Guidelines 7. Handling and storage Ensure adequate ventilation. Keep containers tightly closed in a dry, cool and well-ventilated place. 8. Exposure controls / personal protection Page 2 / 6

3 Component ACGIH TLV Zinc chloride STEL: 2 mg/m 3 OSHA PEL (Vacated) (Vacated) STEL: 2 mg/m 3 NIOSH IDLH IDLH: 50 mg/m 3 STEL: 2 mg/m 3 Legend Component Quebec Mexico OEL (TWA) Ontario TWAEV Zinc chloride STEL: 2 mg/m 3 STEL: 2 mg/m 3 ACGIH - American Conference of Governmental Industrial Hygienists OSHA - Occupational Safety and Health Administration NIOSH IDLH: The National Institute for Occupational Safety and Health Immediately Dangerous to Life or Health Engineering Measures Ensure adequate ventilation, especially in confined areas. Personal Protective Equipment Eye/face Protection Skin and body protection Respiratory Protection Hygiene Measures Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHA's eye and face protection regulations in 29 CFR or European Standard EN166. Wear appropriate protective gloves and clothing to prevent skin exposure. Follow the OSHA respirator regulations found in 29 CFR or European Standard EN 149. Use a NIOSH/MSHA or European Standard EN 149 approved respirator if exposure limits are exceeded or if irritation or other symptoms are experienced. Handle in accordance with good industrial hygiene and safety practice. 9. Physical and chemical properties Physical State Gel Appearance Odor Odor Threshold ph Melting Point/Range Boiling Point/Range Flash Point Evaporation Rate Flammability (solid,gas) Flammability or explosive limits Upper Lower Vapor Pressure Vapor Density Specific Gravity Solubility Partition coefficient; n-octanol/water Autoignition Temperature Decomposition Temperature Viscosity 10. Stability and reactivity Reactive Hazard Stability Stable under normal conditions. Page 3 / 6

4 Conditions to Avoid Incompatible Materials Incompatible products. Strong oxidizing agents Hazardous Decomposition Products ne under normal use conditions Hazardous Polymerization Hazardous Reactions Acute Toxicity Hazardous polymerization does not occur. ne under normal processing. 11. Toxicological information Product Information Oral LD50 Dermal LD50 Mist LC50 Vapor LC50 Category 4. ATE = mg/kg. Based on ATE data, the classification criteria are not met. ATE > 2000 mg/kg. Based on ATE data, the classification criteria are not met. ATE > 2000 mg/kg. Category 4. ATE = 1-5 mg/l. Based on ATE data, the classification criteria are not met. ATE > 5 mg/l. Category 4. ATE = mg/l. Based on ATE data, the classification criteria are not met. ATE > 20 mg/l. Component Information Component LD50 Oral LD50 Dermal LC50 Inhalation Zinc chloride 350 mg/kg (Rat) t listed t listed Toxicologically Synergistic Products Delayed and immediate effects as well as chronic effects from short and long-term exposure Irritation Sensitization Carcinogenicity The table below indicates whether each agency has listed any ingredient as a carcinogen. Component CAS- IARC NTP ACGIH OSHA Mexico Zinc chloride t listed t listed t listed t listed t listed Mutagenic Effects Reproductive Effects Developmental Effects Teratogenicity STOT - single exposure STOT - repeated exposure Aspiration hazard... ne known ne known Symptoms / effects,both acute and delayed Endocrine Disruptor Information Product is a corrosive material. Use of gastric lavage or emesis is contraindicated. Possible perforation of stomach or esophagus should be investigated: Ingestion causes severe swelling, severe damage to the delicate tissue and danger of perforation Other Adverse Effects Ecotoxicity Do not empty into drains. The toxicological properties have not been fully investigated. 12. Ecological information Page 4 / 6

5 Component Freshwater Algae Freshwater Fish Microtox Water Flea Zinc chloride EC50: mg/l/72h LC50: mg/l/96h (Cyprinus carpio) t listed EC50: 0.2 mg/l/48h Persistence and Degradability Bioaccumulation/ Accumulation. Mobility Waste Disposal Methods DOT TDG IATA IMDG/IMO. 13. Disposal considerations Chemical waste generators must determine whether a discarded chemical is classified as a hazardous waste. Chemical waste generators must also consult local, regional, and national hazardous waste regulations to ensure complete and accurate classification. 14. Transport information t regulated t regulated t regulated t regulated 15. Regulatory information All of the components in the product are on the following Inventory lists: X = listed International Inventories Component TSCA DSL NDSL EINECS ELINCS NLP PICCS ENCS AICS IECSC KECL Zinc chloride X X X X X X X Legend: X - Listed E - Indicates a substance that is the subject of a Section 5(e) Consent order under TSCA. F - Indicates a substance that is the subject of a Section 5(f) Rule under TSCA. N - Indicates a polymeric substance containing no free-radical initiator in its inventory name but is considered to cover the designated polymer made with any free-radical initiator regardless of the amount used. P - Indicates a commenced PMN substance R - Indicates a substance that is the subject of a Section 6 risk management rule under TSCA. S - Indicates a substance that is identified in a proposed or final Significant New Use Rule T - Indicates a substance that is the subject of a Section 4 test rule under TSCA. XU - Indicates a substance exempt from reporting under the Inventory Update Rule, i.e. Partial Updating of the TSCA Inventory Data Base Production and Site Reports (40 CFR 710(B). Y1 - Indicates an exempt polymer that has a number-average molecular weight of 1,000 or greater. Y2 - Indicates an exempt polymer that is a polyester and is made only from reactants included in a specified list of low concern reactants that comprises one of the eligibility criteria for the exemption rule. U.S. Federal Regulations TSCA 12(b) SARA 313 t applicable Component CAS- Weight % SARA Threshold Values % Zinc chloride Trace 1.0 SARA 311/312 Hazard Categories Acute Health Hazard Chronic Health Hazard Fire Hazard Sudden Release of Pressure Hazard Reactive Hazard CWA (Clean Water Act) Component CWA - Hazardous CWA - Reportable CWA - Toxic Pollutants CWA - Priority Pollutants Page 5 / 6

6 Substances Quantities Zinc chloride X 1000 lb X - Clean Air Act t applicable OSHA Occupational Safety and Health Administration t applicable CERCLA This material, as supplied, contains one or more substances regulated as a hazardous substance under the Comprehensive Environmental Response Compensation and Liability Act (CERCLA) (40 CFR 302) Component Hazardous Substances RQs CERCLA EHS RQs Zinc chloride 1000 lb - California Proposition 65 This product does not contain any Proposition 65 chemicals U.S. State Right-to-Know Regulations Component Massachusetts New Jersey Pennsylvania Illinois Rhode Island Zinc chloride X X X - X U.S. Department of Transportation Reportable Quantity (RQ): DOT Marine Pollutant DOT Severe Marine Pollutant N N N U.S. Department of Homeland Security This product does not contain any DHS chemicals. Other International Regulations Mexico - Grade Canada This product has been classified in accordance with the hazard criteria of the Controlled Products Regulations (CPR) and the MSDS contains all the information required by the CPR WHMIS Hazard Class Prepared By n-controlled 16. Other information Regulatory Affairs Thermo Fisher Scientific EMSDS.RA@thermofisher.com Revision Date Print Date Revision Summary 02-Feb Feb-2017 This document has been updated to comply with the US OSHA HazCom 2012 Standard replacing the current legislation under 29 CFR to align with the Globally Harmonized System of Classification and Labeling of Chemicals (GHS) Disclaimer The information provided in this Safety Data Sheet is correct to the best of our knowledge, information and belief at the date of its publication. The information given is designed only as a guidance for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered a warranty or quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other materials or in any process, unless specified in the text End of SDS Page 6 / 6